Bently Nevada 3500/72M 176449-08 Recip Rod Position Monitor In Stock

Product Details:

Additional Information:

Description:

The four-channel 3500/72M Recip Rod Position Monitor accepts input from proximity transducers, conditions the signal to provide dynamic and static position measurements, and compares the conditioned signals with userprogrammable alarms.

Each channel, depending on how you configure it, typically conditions its input signal to generate various parameters called measured values.

Use the 3500 Rack Configuration Software to:

Configure alert setpoints for each active measured value and danger setpoints for any two of the active measured values.

Protect reciprocating compressors by continuously comparing monitored parameters against configured alarm setpoints to display alarms and trigger relays, if needed.

Monitor the condition of essential reciprocating compressor machinery.

The 3500/72M Recip Rod Position Monitor meets API 618 requirements for reciprocating compressors. It measures:

Rod position

Rod drop

Hyper-compressor

Use Rack Configuration Software to set alert levels for each value measured by the monitor and danger setpoints for any two of the values measured by the monitor.

Alarms are adjustable from 0 to 100% of full-scale for each measured value. However, when the full-scale range exceeds the range of the transducer, the range of the transducer will limit the setpoint.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause undesired operation.

For I/O Modules with External Terminations, order the External Termination Blocks and cable separately for each I/O Module.

For Internal Barriers, refer to the 3500 Internal Barrier Datasheet (document 141495).

The Recip Rod Position Monitor requires version 3.20 or higher of the 3500 Rack Configuration Software.

Rod Position Single 2 and Rod Position Pair 2 channel types require Rack Config release 6.0 or later.