IPC704 244-704-000-511 Signal Conditioner For Sensors Using Standard Piezoelectric Materials

Product Details:

Description:

The IPC704 signal conditioner converts the chargebased signal from a piezoelectric-based transducer into a current or a voltage signal. This current or voltage signal is transmitted to the processing electronics via a standard 2-wire or 3-wire transmission cable.

The current modulation technique allows transmission over a distance of up to 1 km. A GSI galvanic separation unit is required for this configuration.

The electronic circuitry of the IPC704 signal conditioner is incorporated into a moulded aluminium enclosure. The signal conditioner has configurable high-pass and low-pass filters and an optional integrator to give a velocity output. Furthermore, RFI filters protect the input and output against radio frequency interference and other electromagnetic influences.

A range of installation options are available for the IPC704 signal conditioner, including:

(1) A polyester enclosure providing environmental protection against dust, oil and water jets.

(2) A mounting adaptor allowing the IPC704 signal conditioner to be mounted on a DIN rail.

Two versions of the IPC704 signal conditioner are available:

(1) An IPC704 for sensors using standard piezoelectric materials, for example, CAxxx, CP10x and CP2xx (ordering number 244-704-000-042-...).

(2) An IPC704 for sensors using GaPO4 piezoelectric material, for example, CP50x (ordering number 244-704-000-511-...).

Features

(1) For CAxxx piezoelectric accelerometers and CPxxx dynamic pressure sensors

(2) Configurable high-pass and low-pass filters

(3) Frequency range: 0.5 Hz to 20 kHz

(4) Optional integrator to produce a velocity output

(5) Optional 2-wire current or 3-wire voltage transmission

(6) Certified for use in potentially explosive atmospheres

(7) A range of installation options are available

Order Information