Waste activated carbon regeneration equipment, (granular, columnar) activated carbon regeneration production line

Activated carbon has lost its adsorption performance or its adsorption performance has greatly decreased after use it.Therefore, we need a device to reheat it at high temperature and then inject steam to restore its adsorption performance!

At present, the environmental protection situation is still severe, so the use of activated carbon has always been at its peak. However, the activated carbon after use must be treated. In addition to obtaining relevant solid waste and hazardous waste treatment qualifications, a complete set of production lines for activated carbon regeneration equipment is also required. The following figure shows you:

Ⅰ. The main body of the furnace for regenerating activated carbon: This furnace body is internally heated, gas heated, and has a double layer of refractory material poured inside, which not only ensures the degree of heating of the materials in the furnace body, but also extends the service life of the equipment!

Ⅱ. The overall material of the equipment is carbon steel. At this point, some friends may want to ask, most of the substances adsorbed by activated carbon contain corrosiveness. If carbon steel is used for a long time, will it cause deformation or damage to the furnace body? The answer must be: No, because there are Fire brick inside the converter, workers climb into the furnace to build!

Ⅲ. Feed end of the furnace for regenerating activated carbon: This is the part that receives the raw materials. The raw materials enter the hopper and are transported into the furnace through a high-temperature spiral conveyor. In addition, the sealing performance of this part is also very good, and there will be no smoke or dust flowing out from the feeding end. This is also our company's patented product.

Ⅳ. The steam section of the furnace for regenerating activated carbon: As is well known, the name of activated carbon comes from the fact that carbonized materials require steam to create pores when entering the activation furnace. Therefore, the regeneration furnace also requires steam activation. Waste carbon in a high-temperature state is calcined to burn the substances in the pores clean, and then steam is injected into the activation furnace! Complete the pore reconstruction of activated carbon.