Fixed Type Innovating Aerosol Extinguishing Systems Eco-friendly Clean Agent

Brief requirements of Aerosol Extinguishing Systems according to GA499.1-2010

• Spray process and state-fire extinguishing device should be able to spray normally after switching on the start signal
• During discharge, there shall be no open fire or spark at the nozzle, and no residue shall overflow during or after injection
• After the completion of spraying, the shell shall not be deformed, burnt through or ignited on the surface of the shell.
• The total filling mass of aerosol generator in a fire extinguishing device shall not be more than 10kg, and the deviation of filling mass shall not exceed 2% of its nominal mass.
• The operating voltage of the electric initiator shall not be greater than 24 vd.c.
• The raw materials used to produce aerosol generating agents should be non-toxic to organisms and the combustion products do not contain harmful ingredients that damage the atmospheric ozone layer.

Fireless 125 technical parameter:

FAQ for technical terms

• Do the protected area needed 100% closed?

Answer: no, it doesn’t .

• what is ratio of open area to total area in enclosure?

Answer:Represents the unsealing degree of the enclosed space, and its value is the ratio of the unclosed open area in the enclosed space to the total surface area, expressed as a percentage.

• What is flame extinguishing density?

Answer:The mass of an aerosol agent required to extinguish a fire in unit volume, g/m³.

• What is discharge delay time?

Answer:The time when the fire extinguishing device receives the starting signal and the nozzle begins to spew hot gas sol extinguishing agent.

• What is discharging time?

Answer:The time from the beginning discharging aerosol to discharging stopped.

• What is outlet temperature in discharging?

Answer:During the process of discharge heat aerosol fire extinguishing agent, the outlet temperature is where 5 meters away from nozzle.

• Is there any cooling equipment in the generator?

Answer:Yes, it’s medium or device installed in a fire extinguishing device to effectively reduce the temperature of a hot gas aerosol extinguishing agent before it passes through the nozzle.

Application:

data centers/ UPS/ ESP/ museums/ warehouses/ electric cabinets/ generator rooms panels/ engine rooms/ different transportation vehicles