Hot sellers car Leak Tester
SLA leak test detector has the function of automatic calculation, automatic learning, automatic calibration, also with bar code scanning, remote control and other functions, real achieved the intelligence and simplification.
In the process of actual production and scientific experiment, instead of the traditional method of actual water bubble test and pressurized water bubble, the advantages of non-destructive, fast, data-based and scientific in testing process and results are realized.
The passive execution standard of SLA leak test detector is based on the actual test data and experimental test results to support each other, so must not be misled, or into misunderstanding.
SLA leak test detector allows only a positive misjudgment. That is, products that fall within the critical point of the criteria may be judged as bad, but they will never be qualified. (The critical point of evaluation criteria is theoretically eternal, so need to be upgraded to minimize critical mass in actual production)
Gas source: | 0.4-0.8MPA (clean, dry) |
Power supply: | AC220V(±15%),50HZ,ground lead |
Environmental temperature: | 0-50℃ |
Environmental humidity | ≤95% (not dew) |
Pressure adjustment range: | 0-3Mpa |
Number of test ports: | 1 |
Status of the tested product | With or without hole, finished or semi product |
Pressure mode: | Positive and negative pressure |
Pressure regulation accuracy: | 0.05%F.S/0.02%F.S (Full range accuracy optional) |
Sensor selection range: | 0-10kPa |
Sensor precision: | 0.1%FS |
Pressure minimum setting unit: | 1Pa |
Resolution ratio: | 1Pa |
Dimension: | 335*305*285mm |
Gross weight: | 11KG |