610*1220*245mm Gas Turbine Air Filter Element T512.211.521 Air Intake Filter

Hydrophobic (water proof), moisture proof, Antiflaming.

Salt Repellent – must remove 99.5% of all salt crystals from turbine inlet air.

Wet Burst Pressure – greater than 7500 Pa (30” wc).

Initial Pressure Drop – 180 Pa @ 2500 m3/h (.72” wc @ 1472 cfm).

Temperature Range - -40°C to +90°C (-40°F to +149°F).

Humidity Range – 0 to 100% relative humidity.

Flame Retardance – E d 2 according to EN 13501.

Must result in no (0%) Combustion Turbine Mega Watt power loss in 8000 hours of operation.

Must fit into air inlet systems without modification.

Manufacturing tolerances and joint details shall be such that no gaps or air/water leaks occur in the assembly after installation and during operation.

The performance of the filters is to match (or better) the below charts.

1. Select high-quality and high-efficiency wood pulp fiber materials from the United States and Western Europe, which not only has small aperture, high air permeability, low resistance, high efficiency, but also has a large filter area.

2, using the international advanced new folding process, uniform spacing.

3. The end caps of the filter cartridge and the inner and outer protective nets are all made of high-quality electrochemical plates, which not only have good strength, but also have good anti-rust and anti-corrosion properties.

4, low hardness and high strength closed-cell foam rubber seals are different.

5. Adhesives come from Henkel and do not cause degumming or cracking. Scope of application: gas turbines, centrifugal air compressors and other mainframes

Carcinogenic , Cleanroom , Commercial Building , Computer Lab , Food Processing , Hospital Exams , Hospital Labs , Hospital Surgery , Industrial Workplace , Micro-Electronic Component Assembly , Office Buildings , Pharmaceutical Mfg, Manufacturing Plant