RS232 Commercial Bluetooth Tyre Pressure Monitoring System

Features

1. Prevent accidents

2. Real-time monitoring of tire pressure and temperture to prevent puncture

3. Extend tire life

4. Reduces wear on the suspension system

5. Make driving more economical

Product parameters

component of product

Alarm function

leakage warning

High pressure warning

Low pressure warning

High temperature warning

Low power warning

No signal warning

Parameter Setting

Tire quantity selection setting

Pressure unit setting

Temperature unit setting

Pressure threshold setting

High temperature threshold setting

Restore factory setting

Match sensor(Match tires)

Exchange tires’ position

Intelligent repeater forwarding function

Product attention

Operation is not suggested during driving.

Sensor monitors pressure and temperature of tire and signal to receiver, receiver reports pressure and temperature by number and voice. If there is any abnormal pressure or temperature, flashing warning icon and voice prompt will notice driver immediately.

Drivers need to check and repair the tire immediately, in order to avoid risk of accident due to tire problem.

Tires have natural micro leakage phenomenon. It is a normal phenomenon that pressure of tire decreases over time. Pressure decreasing don't have directly relationship with install this products.

It is a normal phenomenon that pressure is unstable due to thermal expansion during driving. It don't have directly relationship with install this products.

Incorrectly installation will affect the use of this product or make damage. experienced technician is preferred to install this product. please be careful not to damage the sensor transmitter when disassembling tires again. Valve of internal sensor is not available for repeat assembling/disassembling.

Please use power cable provided by factory. It is not allowed to tie receiver by power cable, as I will damage product or effect signal . And you will lose warranty.

Most of the DVD or other high power equipment in the market are all have electromagnetic interference. In order to avoid electromagnetic interference, receiver is suggest to install 50CM away from such kind of products. The best position is upper left corner, upper right corner of A column and middle of front seats (away from control)

There won't be notice if there is any change of products ( performance, specifications, warranty).

* This system send signal by wireless transmission, so it may not receive signal under some certain condition, like interference, error operation or improper installation. If receiver can't receive signal for 10 minutes, please drive car away from current place ( maybe there is strong signal interference ) or go to authorized tire repair center to check is there any problem of sensor or battery of sensor is run out( battery life maybe shorter than normal use, as there is often abnormal condition occurs, sensor need to send signal to warn driver.)