NiCr2MnSi Nickel Based Alloy Wire Good Corrision Resistant Spark Plug Wire
General Information:
2.4146
NiCr2MnSi
17741,17753
Chemical Composition | % |
Ni | Bal. |
Chrome | 1.4~1.8 |
Mn | 1.3~1.8 |
Si | 0.4~0.65 |
Ti | ≤0.15 |
Good corrosion resistance and cold workablity.
Central and ground electrodes of spark plugs. Special designs and special alloys to customer specification.
Delivery status and supply state of furnace resistance alloy heating ribbon
Wire and plate with the looseness or oxidation colour soft modal supply.
Strip except special requirements outside, general with after annealing oxidation colour supply.
The flat silk thread and protecting gas to light after annealing soft modal supply.
2, product packaging of furnace resistance alloy heating ribbon
Wire or strips to pack cloth bandaged volumes supply.
Thread and flat silk, axis encapsulate supply.
3, export products and users have special requirement, negotiation.
Note
1, when the design should be based on the power wiring method, reasonable surface load, the correct choice of silk diameter,
2, before installation coping furnace thorough examination, cleared ferritic, "carbon, and the electric stove contact risks to avoid short circuit, in case caused furnace silk breakdown,
3, when installation should press design wiring method properly connected;
4, in use before should check the sensitivity of the temperature control system, in case of failure, cause temperature burnt.