AME GROUP 1t/H Electric Flat Die Poultry Animal Food Pellet Machine

Introduction for Flat Die Poultry Animal Food Pellet Machine:

This series small flat die poultry animal food pellet making machine is the most ideal equipment to make feed pellets for home use or small farms. This chicken feed pellet making machine can not only produce feed pellets for chicken, but can also produce feed pellets for pigs, cattle, sheep, rabbits, ducks, cattle, other poultry and animals, etc.

Structure of Flat Die Poultry Animal Food Pellet Machine:

Detail Picture of Flat Die Poultry Animal Food Pellet Machine:

Main Parameters of Flat Die Poultry Animal Food Pellet Machine:

Main Features of Flat Die Poultry Animal Food Pellet Machine:

1. Simple structure, wide application range, small floor area and low noise.

2. Powder feeding, no need of adding water. The final feed pellets moisture is low and easy for storage.

3. The results showed that the pellet feed can improve the digestion and absorption of nutrients, and the pathogenic microorganisms and parasites can be killed during pelletizing. The feed pellet is suitable for raising rabbits, fish, ducks and experimental animals.

4. Suitable for all kinds of materials.

Application of Flat Die Poultry Animal Food Pellet Machine:

This flat die poultry animal food pellet making machine can not only produce feed pellets for chicken, but can also produce feed pellets for pigs, cattle, sheep, rabbits, ducks, cattle, other poultry and animals, etc.

FAQ:

1. Why there is no pellet output during pelleting?

A: There are usually 2 cases causing this problem:

1). Die holes are corrosion and has poor finish.

2). Large gap between roller and die plate.

The ways to solve this problem are:

1). Clean the remaining pellet in the die hole. 2). Use oil containing material to make pellets for polishing the die hole.

2. Why the Pellets discharged have much powder or no pellets discharged?

A: There are usually 3 cases for causing this problem:

1). Moisture of material is too low.

2). Moisture of material is too high.

3). Too much crude fiber in raw material.

The ways to solve this problem are:

1). Increase water content.

2). Reduce water content.

3). Add more sticky powder.

3. Why the capacity becomes more and more lower?

A: There are usually 2 cases for causing this problem:

1). Large gap between roller and die plate.

2). Moisture of material is too low.

The way to solve this problem:

1). Adjust the gap between roller and die plate. 2). Increase the water content of material.