Numerical Control Rebar Straightening and Cutting Machine No Scratch

description

Bar wire straightener and cutter for bar is used to straightening galvanized wire or rebar with 4mm-16mm, and then cut it into the needed length. It can do a prepare work for the wire mesh welding machine. So it is widely accepted to the factory who is dealing wire wires and wire mesh. Also widely used in construction area.

Features

Before starting, check that the hydraulic station of hydraulic oil of reducer transmission case whether gear oil filling up before starting the main motor, the examination of the Angle adjustment and the hydraulic system working pressure all lubricating points into the lubricating oil, check the mechanical transmission part of the operation condition to make the shipment wear labor insurance supplies, flexible operating personnel shall not leave after boot string in the hydraulic station of hydraulic oil temperature after reaching stable, the straightening roll up to the initial position of artificial material, steel tube will be delivered after the third of straightening roller straightening roller pressure on the clamping to start the main motor, go round steel tube straightening machine stop at the same time, stop the straightening straightening roller, the straightening roll up, send for inversion of straightening straightening of steel pipe, can pass on the reversal of the knob, make the host inversion and reverse straightening main motor stop, stop the straightening straightening roller, the steel tube was returned to the starting position, to repeat the next stop after straightening procedure instruction, total power close, can not arbitrarily change the program controller

parameters