Garage Door 600kg DC Electric Roller Shutter Motors Home Use

GATECH is specialized in the production of rolling shutter motors and its control system.Our major lines include AC and DC rolling door motors. This roller shutter motor has been continuously exported for over ten years and is our hotting product, it uses the most advanced production technology and the latest technology available to provide reliability with multiple functions.

1. 100% copper wire inside the motor.

2. Transmission mechanism has reasonable design, advanced technology, and specially developed grease, gear not easy wear, durable, low noise, small shaking.

3. Protective measures : Placed inside the motor overheat protector, overheating protection function.

4. Low-voltage and high-DC powermoter, low consumption;

5. Easy manual operation when power failure and it could also be equipped with electrical storage devices;

6. Limit switch unit enables precise adjustment of doors in up and down position;

7. With convenient , stable function of remote control ,long distance remote operation is available;

● The rolling gate machine is a short-time work system, and the continuous operation time should not exceed 7 minutes;

● The operation of the rolling door is controlled by the remote control or the "up", "down" and "stop" buttons on the remote control. When pressing the "up" and "down" keys, if there is no upward or downward movement, you must press the "stop" key to cut off the power immediately to avoid burning the motor;

● In the event of a power failure, use the hand zipper to raise the door curtain. It is strictly forbidden to exceed the set height to avoid damage to the limit switch and cause the top; to close the door curtain, you can gently pull the manual lever to make the door curtain drop at a uniform speed. When the door curtain is about to be fully closed, it should be released pull the rod, and then pull it again to fully close to prevent damage to the limit switch;

● When there is a thunderstorm in the weather, disconnect the external power source as much as possible;

● When using the rolling door machine, the operator shall not leave the scene, and should immediately cut off the power supply if the abnormal situation is found, and then use it again troubleshooting.