Electric Remote Control Car Parking Lock , Anti Theft Car Parking Space Protector

Introduction of SN parking lock:

Parking Lock and Position Lock was used to protect your parking space by standing guard while you and your vehicle are away. You can feel at ease that no vehicle can park in your space and inconvenience you.

Technical parameters of solar type parking lock:

FUNCTIONAL FEATURES INTRODUCTION

• Manual control

If the battery is short of power or out of service, manual control can be made by pulling/pressing the rocking arm of the parking lock, so that the battery can be conveniently taken out for recharging, replacement or maintenance.

• Power Cut-off on Resistance

The power shall be automatically switched off on external forces unaffordable in the lifting of the parking lock to protect the electrical motor from being damaged.

• Power Shortage Indication

When the power is too short to start the parking lock, the indication lamp on the parking lock will flicker for three times to remind the user of recharging the battery in time.

• Alarming and Resetting on External Force

For these series parking lock, if the rocking arm is forced to be lowered when lifting, with the action of the external force, the front/back angle of the rocking arm will be changed, the parking lock will alarm to remind the external force applier to remove external force or remind the managerial staff to make treatment. The rocking arm will reset automatically after 5~7 seconds.

• Theft Protection

The position of the foundation for parking lock and ground installation will be protected by a large external cover. The cover can only be opened by the user with the key to make theft protection.

More photo car parking lock:

INSTALLATION PRINCIPLE AND METHOD

1. Installation Principle

A. Installation Position

The vehicle shall not touch the parking lock when going in and out of the parking space. The parking lock is suggested to be installed in the middle of entrance of parking space.

B. Installation Site

The lock is required to be installed on level and dry cement ground.

2. Installation Method

A. Lift the rocking arm manually with hands, open the lock with key. Open the upper cover to install the lock.

B. Drill three holes (12mm of diameter and 50mm of depth) and install M8 expansion bolts on the ground according to the locations of three installation holes on the parking lock foundation.

C. Cover three foundation spacers on the expansion bolts, and then cover parking lock foundation, install and tighten the bolts to finish installation.

D. Before using, first insert the plug which the color is corresponding to the solar panel lead wire into the battery pins(red for positive electrode and blue for negative electrode). Then set the battery on level position. Insert the plug into the socket of the parking lock, sort up the wires.

E. Install the upper cover. Keep the upper and lower fixed blocks joggling (hold the back of upper cover to push forward as indicated in the schematic). Then lock the upper cover.