IC697PWR724 GE Power Supply, 24 Vdc, 90 Watts

⇒ Click here for good price IC697PWR724

PRODUCT DETAILS

The IC697PWR724 is a 90 Watt, 24 VDC Power Supply Module (PSA) in the GE Fanuc 90-70 Series. Highlights include operation from 24 VDC and three output voltage options for a total of 90 watts (+5 VDC output up to 18 amps; +12 VDC output up to 1.5 amps; and -12 VDC output up to 1 amp). The module features easy slide-in rack mount construction, electronic short circuit overcurrent protection provided on a 5 volt bus, and two rack operation from a single power supply.

The PSA mounts on the rack and plugs straight into a 48-pin backplane-mounted connector in the rack’s leftmost slot. It provides +5 volt, +12 volt, and -12 volt power as well as logic level sequencing signals to the backplane. The IC697PWR724 power supply can be utilized in a single rack application. Additionally, this PSA can deliver power to a second rack assuming the total load is within the appropriate supply rating. Interconnection to the second rack is by way of a prewired cable (part IC697CBL700). Power supply output will ride through a 10 ms total loss of input power at full load. Both overcurrent and overvoltage fault conditions are protected.

This PSA module operates from a 24 VDC nominal line. The power supply can accept an input voltage range of 18 to 32 VDC. For operation at ambient temperatures that exceed 50 C (122 F), the maximum output power must be derated. Please refer to the installation manual for this and additional mounting and ground instructions.

Moore News

NONFERROUS INDUSTRY

Non-ferrous Industry Capability

The sintering method and the Bayer process are currently the main methods for industrial production of alumina.

Most of the alumina produced is produced by Bayer process.

The Bayer-sintering hybrid method was first created, which greatly improved the total recovery of alumina.

With the continuous improvement of production technology, some new production methods such as lime Bayer method and beneficiation Bayer method are continuously applied to production.

The integrated process control system is a distributed control system.

The system consists of eight process control subsystems (workshop) for raw material grinding, lime digestion, dissolution, sedimentation, seed filtration, evaporation, product filtration, and roasting.

Each workshop has an engineering station EWS and 2-3 operator stations OPS.

The data collection, real-time monitoring, data processing and other information transmission of the internal process parameters of the workshop are realized by the EtherNet/IP control network.

The main production operations of the entire alumina plant are completed by these eight subsystems, each controlled by a ControlLogix controller.

More Products

Contact Us

Email: miya@mvme.cn

QQ: 2851195450

Tel: 86-18020776792

Skype: miyazheng520