ND-405DXR NIDEC SHIMPO MICRO NC SERVO DRIVE

Product Details

Circulute 3000 Reducers are internally lubricated using either grease or oil. The following tables describe the type of lubricant that is normally used with these reducers. Because different lubricants may be used for extreme environmental conditions, check the nameplate of the reducer to determine the type of lubricant that is being used. Lubrication quantities listed are approximate.

Follow the instructions below when adding lubricant to the reducer.

Grease lubricated reducers should be disassembled, cleaned and filled with new grease every 5 years or 20,000 hours operation, whichever comes first. Under extreme environmental conditions, the grease may need to be replaced more frequently. The grease should be packed into the reducer in a similar manner to the way that an anti-friction bearing is re-greased. Approximately 50% air space should remain.

Oil lubricated units should receive an oil change after the first 500 hours of operation. After this initial oil change, the oil should be changed after every 5,000 hours of operation or annually, whichever comes first. Under extreme environmental conditions, the oil may need to be replaced more frequently. To drain the oil, remove the oil breather plug and the oil drain plug. To refill the reducer, install the drain plug and remove the level plug. Add oil through the oil fill opening until the oil overflows from the level plug opening. Replace the level plug and the breather.

Moore News

PETROCHEMICAL INDUSTRY
Rockwell Automation serves the entire production chain of oil and gas. The automatic control system uses a monitoring and data acquisition system (hereinafter referred to as the SCADA system).
Centralized monitoring and production operation management of the entire pipeline operation.
The central part of the SCADA system is a computer data acquisition and processing system that communicates with the PLC via VSAT (primary communication channel) and Modem dialing (alternate communication channel).
Process variables are collected in real-time to a central real-time database that displays the process in an intuitive, rich form in the form of lists, trends, and dynamic control flow diagrams.
And provide a variety of data logging and analysis tools to provide an intuitive analysis of the operator's analysis of process operations, predicting process trends, and diagnosing the safety of the entire pipeline.
The station control system uses the ControlLogix system, which represents Rockwell Automation's latest control system technology, as the core controller.

More Products

Contact Us

miya@mvme.cn(Click)

Email: miya@mvme.cn

QQ: 2851195450

Tel: 86-18020776792

Skype: miyazheng52