Servo Web Guiding System Web Guiding Controller Power AC 180~260 V For Face Mask Machine

EPC200 servo edge position controller is a high precision controller with PI control, can choose a variety of detector, to trace edge, trace line. With ultrasonic, photoelectric detector, servo motor/drive cylinder servo system form a servo edge position control system,which can be widely used in printing, packaging, paper making, textile printing and dyeing industry of roll material in edge position control

Function

1. Small size, compact structure, with internal control power supply

2. Using panel membrane switches, simple operation, beautiful and generous

3. Can select ultrasonic, photoelectric detector to trace edge and trace line,control automatically.

4. The advanced PI algorithm , excellent man-machine interface, convenient for user

5. The state of the system parameters have power- fail protection function

6. With functions of RS485 communication interface,with PC, PLC collecting and distributing control system

7. External can connect left and right position limit switch,External center offset adjustment can be performed

8. Can adjust external center- deviation

Introduction:

MC1～+ 12V: connect to start control switch

MC2～+ 12V: reserved control interface

GND1: signal ground

J1～J2: when trouble alarm warning the internal relay operation, the two interfaces connected.

NC: not connected

PE: safety ground

AC220V: controller power supply

8 cores servo motor drive cable socket plug to JP1. 5 cores detector cable socket plug to JP4.External right/left limit switch, should be connect 4 pins JP2 if needed. RS485 communication interface, should be connected to 3 pins JP3 if needed.

Detector connection

movable unwinding edge position controller Installation

Under the drive of motor, unwinding roller and guide roller moving together. Detector must be fixed in the trestle, located in the material entrance behind guide roller.

Material on the guide roller can’t be sliding, need to make sure that the angle of material and roller is big enough in case of sliding, if possible, the material moving direction is opposite with roller rotation direction, in case of sliding.

movable rewinding edge position controller Installation

Detector must be fixed in the moving parts,detector and motor drive moving together, and located in the material entrance behind guide roller.Material on the guide roller can’t be sliding, need to make sure that the angle of material and roller is big enough in case of sliding.Material pre- entrance span P must be smaller.