Button Coin Battery Cell Tester Battery Material dQdV DCIR Pulse Analyzer
The system is oriented to button batteries , super capacitors , three electrodes for testing , mainly for small current batteries , the smallest can reach uA test unit , the system covers DCIR test , pulse simulation test , rate charge and discharge test , cycle life test , etc.
This system belongs to the NEWARE mA - level high - end series of products , supports four-range current range testing , the smallest can reach uA-level test units , the measurement accuracy is as high as one ten thousandth , and the performance of the whole machine is superior.
1. It is equipped with dQ/dV differential capacity curve function.
2. The use of this function can reduce manual calculations and save personnel data investigation time.
3. It is a highly practical device that can meet the needs of universities and research institutions testing needs.
4. This product is oriented to button batteries, super capacitors, and three electrodes for testing.
5. A middle computer can be configured with 8 channels of detection .
6. The system covers DCIR test, pulse simulation test , rate charge and discharge test , cycle life test and other test functions.
7. It is a highly practical product that can meet the testing needs of universities and research institutions.
resolution | AD 24bit , DA 24bit | |
Input Power | 25W | |
Channel Features | Constant Current Source and Constant Voltage Source with Independent pairs of Closed - loop Structure | |
Channel Control Mode | Independent Control | |
Data Recording | Record Condition | Min Time - 100mS |
Min Voltage - 10mV | ||
Record Frequency | 10Hz | |
Charge | Charge Mode | CCCharge , CVCharge , CCCVCharge , CPCharge |
End Conditon | Voltage , Current , Relative Time , Capacity , -deltaV | |
Discharge | Discharge Mode | CCD , CPD , CRD |
End Condition | Voltage , Current , Relative Time , Capacity | |
Pulse | charge | CCC , CPC |
Discharge | CCD , CPD | |
Min Pulse Width | 500ms | |
Automated Switch | Automated swith from charge to discharge for each pulse | |
End Condition | Voltage, Test Time | |
Protection | Software Protection | Power - down Data Protection |
Off - line Testing Function | ||
Setting Protection Condition,Setting Parameter - Low Voltage limit , Upper Voltage limit , Low Current limit , Upper Current limit , Delay Time | ||
IP protection level | Protection level IP20 | |
Voltage and Current Testing Sample | 4 - wire connecting | |
Per Unit Main Channels No. | 8 | |
Dimensions | 3U , 480 – 404 - 130mm |