Mechanical Poultry Manure Removal System,
Automatic Chicken Farm Cleaner Machine
Mechanical Poultry Manure Removal System Quick Information
Mechanical poultry manure removal system or automatic chicken farm cleaner machine for chicken cages use, contains scrapper manure removal system and belt type manure removal system two ways. Scrapper poultry dung cleaning machine is suitable for A frame battery chicken cages, which is put inside of manure pit under the cages, and the size can be provided according to your litter pit dimension. Belt type feces cleaner machine can be for both A and H frame battery chicken cages, the belt width can be served according to poultry chicken cage's width.
Poultry Manure Removal System Features
Belt Type Poultry Manure Removal System | |
1 | The manure conveyor belt for manure cleaner is a thickened PP material, which has strong corrosion resistance, strong environmental adaptability and long life. Moreover, the wear rate of the belt is very low when clean manure, and it can be used for ten to twenty years, which can carry heavy objects, generally one square can carry the limit of 5000N force. |
2 | The conveyor belt manure cleaner motor produced by our company uses a cycloid reducer, and the multi-layers can be equipped with a straight gear reducer. |
3 | High-carbon steel is used for the scraping mouth, and some use high-thickness galvanized steel, which can withstand objects harder than itself without deformation, and the scraper is well-made. |
Scrapper Poultry Manure Removal System | |
1 | It can realize unmanned management, automatic timing cleaning, time can be set arbitrarily |
2 | manual temporary cleaning, simple and quick operation, automatic manual arbitrary conversion |
3 | multi-level power transmission, increased friction, strong power |
4 | automatic retractable scraper, board position Adjustable, low friction, clean manure
|
Installation Precautions
1. It is required that the chicken house must be hardened, the ground is flat, there is no convexity and concave place, the slope control should not exceed 2 degrees up and down. The excrement should be 5-10 degrees lower on the other side. So that the water can be drained smoothly.
2. Place the cages straight and adjust the foot adjuster so that the height deviation between the two cages should not exceed 0.5 mm, and the distance between the legs should not exceed 0.5 mm.
3. Main engine should be firmly fixed, also the head and tailstock should be firmly fixed to the ground without loosening.
4. Install manure belt or scraper, and check whether the manure belt and the manure baffle are suitable.
5. The electrician installs the wiring and control line, and finds the position of the travel switch, and fixes it firmly;
6. The controller must contain a leakage protection device;
7. The test running is performed by a person on the control panel in a jog mode, and multiple persons should cooperate to ensure that there are no scratches, jams, deflection, etc. in the equipment. If problems are found, find out the reasons and solve them in time. Start and run when it is confirmed that there is no error;
8. If the operation is stable, the manure removal is uniform and there is no too much noise (less than 40 decibels). There is not much jitter. That is qualified.