• WS2811 /1903 ic built external.

• Individually control — 1 IC control 3 LED chips.

• Standard reel length: 5 meters/roll, also can be customized.

• Cutted : 3 integrated RGB LEDs&1ic per segment, can be cut per 3 LEDs&1ic.

• Easily cut with wire cutters, there are cut-lines.

• Power supply : must use a 12 V DC power supply to power this strip.

• Do not use higher than 13V,or the entire strip will be destroyed.

• Non-waterproof IP20 + 3M tape on back side of PCB.

• Waterproof : silicon tube casing IP65 +10pcs silicon clips & screw for installation, or 3M adhesive back side.

• Connection : 3PIN JST SM connector on both ends (DC+, DAT, GND),

• DC+ and GND connect to power, DAT and GND connect to controller.

• Extra two wires for power feeding to avoid voltage drop.

• PCB color : white and black.

• LED QTY: 30/ 60LEDs per meter, 1 IC control 3 LED CHIP.

• LED Brightness: RGB (Red 480000mcb, Green 102000mcd, Blue 42000mcd).

• Controller : SD card controller, Artnet, Ardunio, DMX decoder, etc.

Product Features:

Connection Way :

• SPI signal : LED strip + LED power supply + LED controller

• DMX control : LED strip + LED power supply + DMX controller + DMX decoder

• LED controller : SD card controller, RF remote controller, DMX controller, Arduino… ( offline /PC online )

• LED power supply : Meanwell power supply, VL-series power supply( waterproof / non-waterproof )

Controller System:

• Offline controller : K-1000C SD controller supports 2000pixels max.

• T-4000C and K-8000C can control 4000 and 8000pixels.

• Online controller : T-400K, 500K for online working, can controller max 4000, 6000pixels.

• Compatible with DMX, ardunio and the controller who can operate the SPI signal.