Product Discription
LSS Oil Fired Steam Generator
LSS vertical steam power gets vertical pipe structure. There are two lower rings and a special tube between the upper and lower protective tubes to form three combustion gases. Magnification and combustion
For heaters and condensers, the thermal efficiency can be 93% and 100%. The use of steam-water separator and external steam-water separator provides high-quality dry steam, saves fuel, reduces system size and prolongs service life.
1. Easy to maintain:
The inspection door is placed at the bottom for inspection and cleaning of the interior of the oven for easy maintenance.
2. Meets environmental requirements:
High quality and reliable burners allow the fuel to burn completely but greatly reduce harmful emissions from waste. The results of the tests in the respective departments indicate that steam (gas) steam power meets national environmental protection requirements.
3. The evaporation can be increased:
The steam engine can be designed in multiple units (with unlimited quantities) and controlled with a computer. You can add up the overall task. The relevant parts of the steam power (including water treatment, water pump, burner, electronic control box and main valve device) are already in the factory.
4. Installation is complete:
It can be connected to water, electricity and steam pipes on site and save time and effort in installation.
5. Reliable accessories:
Burner support, control box, water treatment and valves, pumps are equipped with national high quality equipment. The support system ensures the safe and reliable operation of the steam power and improves the overall quality of the steam power.
Technical Parameters
Main Technical Reference for Fuel (Gas) Steam Generator | ||||||
Item Unit | LSS0.05 | LSS0.1 | LSS0.15 | LSS0J2 | ||
Rated evaporation | Kg/h | 50 | 100 | 150 | 200 | |
Rated Pressure PTEPREppoPressure | MPa | 0.4/0.7 | ||||
Rated steam temperature | c | 151/171 | ||||
Rated feed water temperature | °C | 20 | ||||
Evaporator efficiency | / | >92% | ||||
Applicable Fuel | / | Gas light oil | ||||
Theoretical fuel consumption | Gas | NM3/h | 4 | 8 | 12 | 16 |
Light Oil | Kg/h | 3.3 | 6.5 | 9.8 | 13 | |
Gas supply pressure | mbar | 60- 100 | ||||
water volume | L | <30 |
Note: The fuel consumption in the table is based on the low calorific value of biomass particles 17084 KJ/Kg (4085 Kcal/Kg).Calculations show that if the low calorific value of biomass fuel is higher than that, the corresponding fuel consumption will be more economical than the values in the table.
Configuration and Interface Size of Fuel (Gas) Steam Generator | ||||||
Item Unit | LSS0.05 | LSSO.l | LSS0.15 | LSS0.2 | ||
Outward Size of Main Engine
(length * width * height) | / | mm | 620*620*830 | 690*690*968 | 750*750*1130 | 800*800*1286 |
Transport Dimension
| / | mm | 206 | 252 | 303 | 350 |
Mainframe Transport Weight | DN | mm | G 1/2- | Gl' | Gl" | G 1* |
Main Steam Valve Pipe Diameter | DN | mm | Gl/2" | Gl/2- | Gl/2- | Gl/2° |
Feed Water Valve | DN | mm | G1 1/4” | G11/4- | G11/4- | G11/4- |
Safety Valve Diameter | DN | mm | Gf | GF | Gl" | Gl" |
Drain Valve Pipe Diameter | DN | mm | 133 | 133 | 159 | 159 |
Remarks: We will reserve rights to change the above mentioned data due to continuous policy transformation and product improvement.