VT900-G car GPS tracker Description:
The car GPS tracker can help you locate and track your vehicles including cars, trucks, vans, motorcycles, etc. iStartek not only offers GPS fleet tracking devices with basic features, such as real-time tracking, SOS alarm, and geofence, ACC detection but also supplies vehicle trackers with high-end functions, such as temperature monitoring, fuel monitoring, RS232, OBD connect port. Equipped with a GPS tracker for vehicles, you can enhance fleet security, improve stolen vehicle recovery(SVR) rate and maximize each vehicle runtime.
Air Interface Protocol:
Transmit Protocol | TCP, UDP, SMS |
Scheduled Report | Report position and status based on preset time intervals, distance, mileage or a combination of these settings |
Geo-fences | Geo-fence alarm and parking alarm |
Low Power Alarm | Alarm when backup battery is low |
Power On Report | Report when the device is powered on |
Antenna Disconnect Alarm | Alarm when external GPS antenna is disconnected (customizable) |
Driving Behavior Monitoring | Aggressive driving behavior detection, including acceleration, deceleration, speeding etc. |
Remote Control | OTA control of digital outputs |
FOTA | Support firmware upgrade over the air |
Standard Accessories
VT900 car GPS Tracker | GSM Antenna | GPS Antenna | Power Cable |
Application:
1. Fleet Management
2. Vehicle Tracking
3. Bus
Interface:
Product use
1 Charge
For the first time using the VT900 G, please connect the DC (positive) and GND (ground) to the 12V or 24V power supply
for at least 2 hours to ensure sufficient power. After configuration and testing, install it on the vehicle.
2 Insert SIM Card
The device supports SIM cards of 2G and 3G networks;
Please ensure that the SIM card has sufficient balance, and has opened the GPRS function and obtained the correct APN
of the SIM card;
Please make sure that the PIN lock function of the SIM card has been turned off;
If you need to use the call to reply to the location information function, please make sure that the SIM card has caller ID
function;
a. Make sure the device is turned off before installing the SIM. Unscrew the front baffle screw and take out the PCBA
b. Insert SIM Card
c. Fit on PCBA and screw on the screw