Aftermarket Fuel Injector Cleaning Machine Top Fuel Injector Cleaner
Description
At present, most of the cars on the market are 2-6 cylinders. Most of the injector cleaning instruments on the market are 2 cylinders, 4 cylinders and 8 cylinders. But in fact, these are not practical. First of all, in terms of quantity, the two-cylinder can not meet the 4-8 cylinder model, and the eight-cylinder will cause waste of resources. In addition, in terms of price, the price of the 8-cylinder is more expensive.
Therefore, the 6-cylinder machine can not only meet the needs of use, but also the price is relatively cheap.
Specifications
Voltage | AC220V |
Ultrasonic power | 100W |
Relative humidity | <85% |
Intensity of outer magnetic field | <400A/m |
Size | 60*60*42cm |
Voltage | AC220V+10%50Hz/60z |
Injecting Flow Test
Injecting flow test is to check if the injecting flow in 15 seconds meets the specifications for injecting amount. The deviation reflects the wear or clogging in the injector, instead of electrical parameter variation.
Reverse flush
Injector Cleaner& Tester can also perform reverse flush by connecting with flush-back adaptor at [Uniformity/Sprayability test] mode. Reverse flush is a way to clean the injectors with the test liquid flowing from the outlet to the inlet of the injector. Reverse flush may remove the dirt inside the injector or the injector Strainer(0nly for the top fuel supply injector).
Note:
1. The system pressure can be adjusted by pressing [reduce pressure]/[boost pressure] key when performing reverse flush.
2. It is advisable to press[Drain] key to avoid spillover of test liquid during reverse flush.