RFID Card Inlay Sheet Chip Hole Die Cutter YHP-3000 One Time Punching

1.Machine Introduction of RFID Card Inlay Sheet Chip Hole Die Cutter YHP-3000 One Time Punching

RFID Card INLAY Sheet Hole Puncher YHP-A+ is designed to punch both two side position holes and chip fixing holes (like 24 hole for 3*8 layout) for installing COB chips in the INLAY sheet middle layer in the process of RFID card INLAY sheet production.

The machine is specially designed for punching the side positioning holes (Usually two holes) and contactless or RFID card chip fixing holes on INLAY middle sheet at the same time.

This hole punching machine uses to punch of the positioning hole and the clearance hole on PVC, PETG and ABS sheets with different thickness and size for contactless cards (RF cards). Control by the servo system and use the precision mold to punch, which ensure the quality of the products and improve productivity, only need one operator.

In the machine structure, the machine is easy to operate and maintain, which enhances the service life of machine and productivity.

2. Feature Descriotion of RFID Card Inlay Sheet Chip Hole Die Cutter YHP-3000 One Time Punching

• The position precision of all the punched holes is made accurate because all the holes are punched at the same time.
• It features very high speed, very easy operation and very high precision.
• The mechanical structure is so reasonably designed that the punch mould can be easily changed as per the different INLAY sheet layout (such as 3×8, 4×8 and 5×5 layout).

Main technical parameters

Technical Parameters

1. Speed: 800-1200 sheets per hour.

2. Operator needed: 1 person

3. Compressed air: 5-6kg/cm2 30 liters/minute

4. Gross weight: 18 kg

5. Dimension: L600×W550×H800

3. More Characters of RFID Card Inlay Sheet Chip Hole Die Cutter YHP-3000 One Time Punching

1. Punch the hole for the chip of the inlay, which ensures the modules and the PVC embedding on the same plane and protects the chips.

2. The machine has two molds with two different sides, it can be used for different production technology, just press the switch to select the mold.

3. The pitch and the size of the punching mold can be adjusted according to the requirement.

4. The cylinder drives punching mold up and down with the low noise.

5. PLC control and can be punched different layout,

6. Use the precision mold to punch and ensure the quality of the products.

7. The life span of the mold is: It only needs to be whetted every two million times punching

8. Punching with the low noise.

9. Materials are loaded using the dowel pin, easy to adjust.

10. Use the servo system to position which ensure the position accurately

11. Use the PLC and the touch screen, stable and visualized.

12 .HMI system make communication easier.