It is a fully automatic machine with several great functions, such as excellent recovery rates.It is quite tall and comes up to your hip, enabling you to comfortably use the controls since they are situated at the top of the unit. Complementing the controls are the wheels so that you have no issues with movement.

Furthermore, it is multi-purpose, and you can use it for recycling, recharging, vacuuming, injection, and a leak test. Now, given that it is user-friendly, you will have no trouble injecting the dye and lubricating oil into it.
Moving on, due to the self-purge mechanism, it automatically purifies the air to prevent pollution. Plus, you can maintain a preselected level of refrigerant, thereby allowing you to refill it easily.Finally, it has an advanced monitoring system that informs about leaks and the remaining time for the vacuum.

Main features

a. Recovery : Recovery refrigerant automatically , and the refrigerant meet the SAE standard .

b. Charge : Charge refrigerant into the the perfectly sealed air condition system . Manual operation to purge the waste compressor oil and charge the new oil .

c. Vacuuming : Draw out air from conditioner .

d. Equipped with filter device to eliminate moisture and impurities .

e. Drain compressor oil automatically

f. Fully automatically operation .

Features

a . Recycled : Separation of oil and water from , the recovered refrigerant meets the standard of SAE , thus it can be reused for the vehicles air conditioning .
b . Charge
c . Separate compressor oil from the refrigerant and charge new oil .
d . Filling : New oil and refrigerant refilling can be easily set up .

g . Equipped with filter device to eliminate moisture and impurities .

Technical data

Refrigerant Recovery Procedure

Using a recovery/recycling machine is not difficult. The basic procedure goes as follows:

1. Connect the hoses on the recovery machine to the service fitting on the vehicle.
2. Turn the recovery unit on following the equipment manufacturer's operating instructions. Allow the machine to continue pulling refrigerant from the system until it indicates all of the refrigerant has been recovered (system pressure reads vacuum and holds vacuum for at least 5 minutes). If the machine does not have an automatic timer or shut-off, discontinue recovery at this time, and close and disconnect the service hoses.

TIP: If A/C components show evidence of icing during the recovery process, the components can be gently heated to speed up the flow of refrigerant. Use a hot air blow dryer, never any type of open flame, to heat parts.

3. Once the recovery process is complete, determine how much oil was pulled out along with the refrigerant so you can replace it when the system is recharged. Most machines have an oil cup that will show how much oil was taken out. The cup should usually have about one ounce of oil in it if the system contains the proper amount of oil. If the system is low on oil, there may be little or no oil in the cup. On the other hand, if the system is overcharged with oil, there may be several ounces of oil in the cup.

4. After the refrigerant has been recovered, the recycling process can begin. The time it takes to clean the refrigerant can vary from 20 minutes up to an hour depending on the amount of contamination. During the recycling phase, the refrigerant is filtered and dried. Particulates, moisture, oil and air are all removed until the refrigerant meets purity standards. A moisture indicator light usually signals when the job is done. The refrigerant can then be put back into the vehicle, or saved and reused in another vehicle.
Most machines use "single-pass" recycling where the refrigerant makes only one pass through the cleaning circuit, but some machines also offer "multi-pass" recycling or a choice of single-pass or multi-pass cleaning. Multi-pass cleaning takes longer but may be necessary with refrigerant that contains a lot of moisture.