390ml 3:1 High Tensile Strength Chemcial Anchor Adhesive For Thread Rods
Chemical anchor adhesive, epoxy injection mortar, Chemical fixing glue,
Chemical anchoring system used for anchoring and rebar connections in concrete.

Item #: FixingChor139
Capacity: 390ml
Materials: Epoxy
Mixing Ratio: 3:1


Product Description:

390ml 3:1 High Tensile Strength Chemcial Anchor Adhesive For Thread Rods is

a high performance, two components pure epoxy resin system. strong fixing with exceptionally

high chemcial resistance.Applied in one single action this resin will produce a high performance,

Characteristics

Used for studs and relatively small diameter rebar. ⋅

Fixings in concrete, wood, or other high strength materials.

Suitable for medium loads and non-critical applications.

Fast working times for early loading in time sensitive applications.

Use in extremely cold environments and fixings holes.

Good durability formulation, resistance to chemicals.

Application Range

Fixing of the following substrates:

Concrete

Hard natural and reconstituted stone

Solid rock and masonry

Metal Work, carpentry

Fixing of handrails, balustrades and supports

Fixing of railings

Fixing of window and door frames

Mechanical and electrical services installation

Anchoring of supports for ducting and equipment.

For structural work:

Rebar / steel reinforcement anchoring in new and refurbishment works.

Threaded rods

Bolts and special fastening systems

High bonding strength,

Can be applied in severe environment

With molecular structure combining the Hydrophilic group and hydrophobic group

Can operate and keep high performance in environment of moisture, hot and still

works even if the surface of hole is smooth.

Non-cracked concrete

Can use in damp area

High load capacity

Non-sag, even overhead

Styrene-free

Low odour

Non contraction after harden

High stability

No transportation restrictions

Good elongation property

No breaking under high stressing.

repristinate after stressing.

ATTENTION

- Do not install anchors when the temperature is less than 10°C.

- If the cartridge is not finished, please clean the opening, then put the plug back and cap tightly.

- At temperatures below 10°C should be warmed or stored in temperatures

of 10-30°C for 24hours prior to use to improve product flow and cure.

- If the gelling time expires, please use a new static mixer.

- Do not cut or shorten nozzles.

- It can be used again in the future by replacing the static mixer.

- Please ensure hole is properly cleaned. Hole may be damp but must be free from water.

- Do not install anchors when substrate temperature is less than 0°C.

r.