Taiwan Standard 200gsm Carbon Fiber CFRP Wrap for structural strengthening

Weight: 200gsm

Density: 1.8g/cm³

Packing: 100 meters/roll

Width: 100mm, 200mm, 300mm, 500mm or to be customized.

Storage Condition:Store dry at 40°-95° F(4° -35°)

Shelf Life: 50 years

Color:Black

Carbon Fiber Type: 0° (unidirectional)

Taiwan Standard 200gsm Carbon Fiber CFRP Wrap for structural strengthening

Carbon Fiber Reinforced Polymers CFRP Wrap for Structural Strengthening. These fabrics are applied onto the surface of existing structural members in buildings, bridges and other structures. The result is an externally bonded CFRP (carbon fiber reinforced polymer) reinforcement system engineered to increase the structural performance

A mix of usually carbon fibre fabrics, and an epoxy resin, wrapping systems are custom designed for each project and application. Where there is an element of corrosion in the structure, carbon fibre wrapping can be used to both weather-proof corrosion and structurally re-enforce the structure. The impervious material will protect a structure from moisture intrusion and further corrosion, reducing the need for ongoing maintenance work.

The primary benefit of CFRP systems versus traditional retrofit and repair methods is that significant flexural, lateral, axial or shear strength gains can be achieved with an easy-to-apply composite that does not add significant weight or mass to the structure of building, highway, bridge, tunnel.

Advantages

Used for shear, confinement, seismic or flexural strengthening

Versatile, can be wrapped around complex geometries

High Strength

Light Weight

Non-corrosive

Alkali Resistant

Low aesthetic impact

Application

Basements Driveways

Patios Pools

Small Industrial Parking Garages

Buildings Bridges Piers/Wharfs Tunnels

Roads Sidewalks Stadiums Shopping Malls

Schools Dams Tanks/Silos Pipes

Blast Reinforcement

Military

Preparation works

Surface must be clean and sound. It may be dry or damp, but free of standing water and frost. Remove dust, laitance, grease, curing compounds, impregnations, waxes, foreign particles, disintegrated materials and other bond inhibiting materials from the surface. Existing uneven surfaces must be filled with an appropriate repair mortar. The adhesive strength of the concrete must be verified after surface preparation by random pull-off testing (ASTM D 4541) at the discretion of the engineer. Minimum tensile strength required is 200 psi (1.4 MPa) with concrete substrate failure (typical).