Function:

Shear & end welder parallel cuts the head of the strip coming out of uncoiler and the tail of the strip steel going into the accumulator, and weld them together to form a smooth and continuous line of strip steel.

Features

1. Adopt oblique shear; Two down knives should be fixed on the down knife base. The base is connected to the frame with screws. The up knife should be installed on the moving frame. There is an oil tank to move for up knife support frame.
2. Tighten; The position should be on the frame. Make two strips to keep the level and press; Tighten the position to make right and left parts; It can be controlled the air cylinder by footswitch.
3. To butt joint of right and left two pieces of the strip, clamping the middle of copper electrode plates by clamping device; The welding torch should be fixed on the moving slider, It can be drive by screw shaft.
4. The screw shaft drive by the motor; The motor can be adjusted speed by the inverter output frequency, then adjust the speed of the welding torch.
5. The indicator is light for right and left, it shows pressing tightly. on the contrary, it sends the materials.
6. It can be controlled by a footswitch for right and left tight; The device will be a move for foot action.
7. The shear footswitch is in the middle; The up knife will cut down for pressing the switch; Then the up knife will be back for loosening the switch.
8. Adjust method: arc strike at edge 1-2.5mm; arc failure at edge 0.5-4mm.
9. Motorized button: there are front and back buttons; it can be adjusted the welding torch position by hand.Position by the indicator.

FAQ

Q: Are you a manufacturer?
A: Yes, we are a manufacturer. We have 4 factories ( Machining, Assembling, Heat treatment, and Moulding ). We also have our own R&D department. Welcome to visit us.
Q: What kind of payment term do you do?
A: We do T/T.
Q: What info do you need before giving me the price and proposal?
A: Since we design individual machines based on our customer's requirements, we need your desired products' basic dimensions, including all the pipe diameter(or tube length), thickness range, usage, raw material steel grade, coil weight, and degree of automation.
Q: What should I do if I just start a new business?
A: Contact us immediately, we provide a free consultant for pre-sales service. Also, we can help you solve the raw material (steel coil) purchase, worker training, international market price, and more.
Q: How do you do QA?
A: We have a special team to do strict QA, this is one of our strengths:
(1)Every gearbox will be tested for 8 hours with oil inside to guarantee there is no leak.