The product is manufactured using a stainless steel core and polypropylene to create the brush

1m length with a diameter of 100mm polypropylene brush that helps prevent leafs, twigs, moss etc building up and blocking guttering systems.

Gutter Cleaning Tool Brush Features & Benefits

• Stainless Steel wire centre
• Very easy to install and fits almost all types of gutters, Square, Round & Ogee
• Maintenance Free
• No need for annual cleaning
• Available in Black, White & Brown

TEN PCS TO ONE CARTON . ONE PC WITH LOGO CARD

Size:10*100CM,12*100CM,10*200CM,12*200CM,10*300CM,12*300CM,10*400CM,12*400CM

Hefei Weixuan Wire Brushes Factory is specialized in manufacturing nylon wire brush for many years.

With an experienced and professional team, we have exported our products to many countries

and regions all over the world, especially Europe. Our products enjoy a good reputation among our customers.

Now, we can offer different wire material and different wire colors of gutter cleaning brushes

(1) Nylon wire gutter cleaning brush

(2) UV resistant PP wire gutter cleaning brush

(3) Stainless steel wire gutter cleaning brush ;

(4) nylon chimney brush ; and so on,

Great welcome to contact us.

How to install the Weixuan Nylon Gutter Cleaning Tool Brush

Before installation ensure that any leaves/debris are removed and the gutters/drains are clean.
It is very important that the correct diameter brush is chosen for your gutters or drains. The brush must fit snugly in position without any gaps either side. If the brush is allowed to ‘rattle’, it will be much less effective and is likely to be blown out. If you measure the inside width of the gutter and it is, say 90mm, the correct diameter of brush would be the standard 100mm diameter.

The filaments at the top of the brush should extend slightly above the level of the tiles or slate.

N.B. Although perfectly suitable for standard 100mm square or round profile gutters, the 100mm diameter Gutter brush will suit most gutter profiles and styles including Deepflow, Ogee and Classic profiles.

The brushes should run continuously along the whole length of your guttering. When one brush finishes, bend the excess wiring at the end of each brush backwards to form a hook and simply attach the two brush ends together to continue the run. The brushes can run directly across the down pipe or drain outlets. If there is excess brush at the end of the run, just cut the excess of with a pair of wire snips but make sure you leave approximately 50mm overrun, then just untwist the wire to remove excess filaments, re-twist the spine and bend into a hook shape and secure into the gutter. Job done!

Before installation ensure that any leaves/debris are removed and the gutters/drains are clean.