YE0178 BlankFilm White Balacing Test Target 4:3 Ratio 100% WHITE TEST CHART Shading Measurement Chart

The test chart consists of a blank film between two glass panes. The (reprographic) film is of the same material as the other ESSER TEST CHARTS transparencies (D280, D240, D205).

The test chart is designed for shading measurement under the same lightning conditions as other transparency measurements.

It is possible to perform shading measurements on illuminator (LG2, LE6) without any chart. But then lightning conditions are different to other measurements with test transparencies. By using a test transparency the light intensity of an illuminator changes. This is caused by two superimposed factors

a) the filter effect of the film and glass (25% light absorption) and

b) the light remission of the transparency ack in the illuminator

While factor a) is predominant with the LG2, the remission factor b) is predominant with the lightning sphere LE6, i.e. the light intensity rises significantly when a test chart is inserted. To carry out shading measurement under the same lighting condition as other measurements the use of the YE0178 is essential.

Definition of white shading or white level uniformity

Determination of maximum white level variations in various areas of the picture, when the camera is directed at an evenly illuminated test chart.

Measuring equipment

Oscilloscope; video amplitude meter

Measuring conditions

Gamma correction: ON

Iris aperture: F/4 2/3” CCD

Gain: 0dB

White balanced

The illumination of the test chart has to be adjusted so that the R, G, B output signals are equal to 700mV/75ohms (nominal amplitude). Lens initially focussed on the test chart (or an other suitable test chart

e.g. YE0120) and then de-focussed.

Shading correctors: ON

Zoom: Positioned to minimize the effect of vignetting and shading of the test chart.

Measuring procedures

Measurements are made on the R, G, B signals at the camera output and then repeated for two picture zones defined as follows:

a) within a rectangular zone, the height and width of the picture (zone A)

b) outside this rectangle (zone B)

On the basis of these measurements, the differences of level for R-G, R-B and B-G are calculated and the maximum peak-to-peak variantions recorded for each zone.

Presenting the results

The results, expressed in % of the nominal signal, are recorded in a table:

Suzie Xia
International Sales Dept.
--------------------------------------------------------------------------------
Shenzhen ThreeNH Technology Co., Ltd
Add: 4/F, Building 8, Nangang Second Industry Zone, Xili, Nanshan District, Shenzhen, 518055 China.
Tel: 0086-755-27198826 Ext: 601
Fax: 0086-755-27190609
Mobile: 0086-13510878132
Email: y@3nh.com
Skype: y@3nh.com
WhatsApp/Wechat: 86-15019429968
Website: www.3nh.com/en