80 PLUS power supply 500w Desktop PSU RPD500-60EGN
The Product Features

• Worldwide Input Voltage 100Vac-240Vac
• Active PFC Within 0.99 Power Factor Correction
• Dual 12V Rails To Fulfill System Protection Demand
• Own Patent IC To Offer High Performance And Efficiency
• 12cm Fan Provide Ultra Silent User Environment

PC PSU Introduction

• Dimension 140 (L) x 150 (W) x 86 (H) mm
• Output Wattage 500W
• Efficiency 87% 90% 87%

The PC PSU DESCRIPTION

This specification describes a 500 watts power supply. With 6 output, and remote ON/OFF control for ATX-12V system and a “Power factor correction (active PFC)” circuit at 100V-240Vac.

APPLICATION: Desktop

WATTAGE: 500W

DIMENSION : 140mm(L) x 150mm(W) x 86mm(H)

PRODUCT HIGHLIGHT

• Efficiency Level: 80PLUS Gold
• Erp Lot: <0.5W
• Input Voltage: 100~240Vac

INPUT SPECIFICATION

• Input Range: 100-240 Vac
• Input Frequency: 47-63 Hz
• Input Current: 115V@ < 8.0 Amps - rms 230V@ < 4.0 Amps - rms

OUTPUT SPECIFICATION

Output Rise Time:

• +3.3V 20mS (maximum)
• +5V 20mS (maximum)
• +12 V 20mS (maximum)
• -12 V 20mS (maximum)

Hold up Time: 115V/60Hz 17mSec. Minimum@100% Load,

GENERAL SPECIFICATION

• Efficiency: 87%@ 20% load; 90%@ 50% load;87%@ 100% load
• PWOK Delay Time: 500ms > PWOK > 100ms
• EMC Performance: EN55022 class B

​ENVIRONMENTAL SPECIFICATION

• TEMP.Range: Storage Temperature: -40°C to + 70℃
• MTBF:The power supply reliability, when calculated by “Bellcore” latest revision are exceed 100,000 hours with all output at maximum load and an ambient temperature of 25℃.

Output Voltage and Current Rating

NOTES

1) +3.3V & +5V total output not exceed 130W.
When +5V is load to 22A, the +3.3V maximum load is 3A. When +3.3V is load to 24A, the +5V maximum load is 10A.
(2) +12V1 & +12V2 total output not exceed 432W(36A).

(3) All outputs shall be safety-isolated from the AC mains and share a common return. This common return must be connected to supply chassis.

(4) Voltages and ripple are measured at the load side of mating connectors with a 0.1uF monolithic ceramic capacitor paralleled by a 10uF electrolytic capacitor across the measuring terminals.

This content is subject to change, please refer to specification for more detail.