Vertical 76mm Dia Belt Conveyor Rollers 3.0mm Thick For Heavy Duty

Heavy-Duty Belt Conveyor Vertical Roller Aligning Roller Group

The vertical roller is mainly connected with the self-aligning bracket. It is a product used in the self-aligning roller. The vertical roller is installed on both sides of the conveyor belt to prevent the conveyor belt from deviating. That is to say, when the tape deviates, one of the wing rollers is squeezed, the vertical roller rotates around the shaft on the rotating mechanism through the moving rod, the shaft drives the pull rod to rotate, and the final pull rod pushes the entire roller set to rotate by an angle, so that the tape runs smoothly , Adjusting the center, and simple structure, can meet the needs of modern operation development.

The influence of the flexibility of the roller on the belt conveyor:

During the operation of the belt conveyor, the flexibility of the roller is very important. If the roller is not flexible and the coefficient of rotation resistance is high, the entire belt conveyor system will have to pay a lot of power and consume a lot of electricity. Sometimes it will cause the tape to tear and the motor to burn out. In severe cases, it can cause a fire. Therefore, the selection of idlers with low rotation resistance coefficient (well less than 0.020) is an important part of the design and selection of belt conveyors.

How to maintain the sealing performance of the Impact roller?

(1) The labyrinth seals should be made of original parts, and should be put into the rollers during assembly, and should not be assembled together.

(2) For the sealing performance and use performance of the roller, it is forbidden to disassemble the roller at will.

(3) The normal service life of the roller is more than 20000h, and generally does not need to be repaired. However, according to the place of use and the size of the load, the corresponding maintenance date should be established, and the oil injection maintenance should be cleaned in time, and the floating coal should be cleaned in time. The rollers with abnormal noise and non-rotating should be replaced in time.

(4) When replacing the bearing, the opening of the bearing cage needs to be opened outwards. After the bearing is installed into the idler, the proper clearance should be maintained and it should not be crushed.

(5) During the use of the idler, prevent heavy objects from hitting the idler tube.