The servo feeder adopts the combination of high-tech force distance and position control, servo motor and its driving power, and is equipped with high-speed calculation and precise control. It has a good man-machine interface and completely shakes off the traditional power transmission, pressure transmission and A new type of feeding device that mechanically adjusts the feed length.

It can be matched with high-speed large-step feeding of punching machine, and the feeding is accurate and reliable. It can also cooperate with various working methods to improve the flexibility of the machine, simplify the operation steps and greatly improve the production efficiency.

First, the servo feeder adjustment test example:

1. Start the correcting machine or material holder and slowly release the material. The servo feeder adjusts the position of the two stopper wheels according to the width of the material, so as not to hinder the operation of the material.

2. Relax the cylinder on the platform, put the material between the upper and lower rollers, put down the cylinder to press the material, adjust the air source pressure gauge to avoid the material is not tight and slip, resulting in inaccurate feeding. When the thickness of the material changes, it must be readjusted. .

3. After setting the feeding length, look at the actual situation, and set the feeding speed accordingly. The method of setting is described in detail in the previous section.

4. After the relevant parameters of the feeding are set, the actual feeding length is not the same as the set value due to the number of the divisor. Therefore, in the manual mode, press the feeding test, punching, stroke, stamping, and adjusting the feeding. The actual length.

5. The adjustment of the feeding start is adjusted by the rotating cam of the punching machine. The so-called feeding start signal is to start at which angle of the punching crankshaft.

Specification:

Straigtening performance:

*1:(Pneumatic):Option in case of pneumatic mandrel expansion is provi