NKS Type Best Price Ultrasonic Dental Air Scaler 4 Hole / 2 Hole With 3 Scaling Tips

Ultrasonic Dental Air Scaler Handpiece Nks Type 4 Hole / 2 Hole With 3 Scaling Tips

Feature
1. Brand New; Durable; 100% CE High Quality.
2. One Handpiece Plus 3 Compatible tips: S1 S2 S3.
3. Easily attachable to any 2-hole borden handpiece connector
4. SKU: JK-E-QD(N)-B-B2


Specifications
Available air pressure: 3.2 KG/c㎡
Sterilization: High-temperature (135 Degree) and High-pressure repeatedly
Available Air Pressure: 2.5~3.5KG/c㎡
Air Pressure: 2.8KG/c㎡
Air Volume: 15~24L/Min
Sound Level: 65-68 dB
Net weight: 0.12kg
Gross weight: 0.15kg
Packing size: 170*80*30MM


Caution
1. The air supply must be free of moisture. The water supply must be filtered.
2. Place the most priority of the patients safety
3. Do not exceed 0.28Mpa(2.9kgf/cm2)when setting the air pressure at the dental unit.
4. If any abnormalities are found in use, stop using immediately and contact your dealer.
5. Do not drop, hit, or subject to excessive shocl.
6. Check the vibration, noise and overheating outside of the patient's mouth before initial use. If any abnormalities are found in use, stop using immediatel and contact your dealer.
7. Be sure to stop the air supply, and replace the tip ro the coupling joint.
8. Watch out the sharp point of the tip.
9. Do not use a spray lubricant. Limited air discharge orifice size of the scaler forces the propellant pressure to build up inside, and the scaler may fly off.
10. Do not clean or wipe the scaler with highly oxidized or acid water or strilizing solution.


Installation
1. Holding the tip-end, turn clockwise and fasten securely tighten with wrench.
2. Shout off the water supply. Adjust air pressure to 2.8KG/CM2 Adjust the water flow until a fine mist ejects from the tip.
Lubrication
Supply 2-3 drips into the drive air tube once or twice a day or spray lubricant into inlet hole of handpiece for about two seconds.


Content
scaler handpiece * 1
work tips * 3
Wrench * 1