Precautions for ultrasonic atomization:
1. when the nebulizer is working properly, please do not put your hands above the spray chamber of the nebulizer to prevent ultrasonic injury.
2. The atomizer can work normally only when it is in the water. Before use, please put it into the water and then connect the power supply, and make sure that the atomizer surface is in the state of water to avoid damaging the atomizer.
3. Please disconnect the power supply before using the atomizer, and then take out the atomizer from the water.
4. When using the atomizer, please select a power supply with an output power of more than 350W and an output voltage of dc45 ± 5V. The power supply should isolate the fog to prevent the fog from getting into the power circuit board, short circuit and burning the power supply.
5. When multiple atomizers are placed in the same container for use, they need to be separately equipped with power supply. It is not allowed to connect multiple atomizers with a single power supply for use, and attention should be paid to making the shells of each atomizer conductive to each other to prevent electric corrosion during operation.
6. the fog generated by the atomizer must be forced to be discharged by fan, and each group of atomizers shall reserve a plane space of 350CM2 to avoid the high water temperature and shorten the service life of the atomizer.
7. The atomizer is not suitable for atomizing corrosive liquid, so as to avoid damaging the metal shell and atomizing sheet of the atomizer.
8. Please do not damage the water level sensor switch during the installation process, so as to avoid the atomizer out of control due to the failure of the water level switch. Stop using when the water level switch is damaged, otherwise the atomizer will be further damaged due to dry burning of the atomizer. At this time, it can only be used after being repaired by professional maintenance personnel.