Universal 4 Button Face to Face Clone Remote Control 4 Button
New Universal Multicode+Multifrequency, Generate 19 brands. More than 20 remote models no need ORIGINAL remotes.

Duplicate Procedures:

1. Put the EPIC close to original remote, around 3-5cm, head to head.
2. Keep pressing the button 1 of EPIIC, press 3 times button 2 of ERIC. LED emits slow flashing. Release buttons.
3. Keep pressing the button of original you want to copy until LED of EPIC emits quickly flashing.
4. Then press the button of EPIC you want to store, LED of EPIC keeps on then turn off. Duplicating finished.

Program EPIC to original receiver

following original procedures

To proceed with EPIC recognition on the receivers (in model list with D.T.P marking), keep pressing EPIC more than 6 seconds, LED of EPIC emits quick flashes until LED turn off.

Special Remote models

Program to receiver

1. For some models, it requests to send seed code like BFT, to copy these original remote models please follow below procedures.
2. After duplicating original remotes with seed code, keep pressing button 1 and button 2 for 3 seconds, LED of EPIC emits quick flashing, enter into seed code sending mode.
3. Press the button of EPIC that send seed code, EPIC starts to send code.

Special Remote models

Duplicating procedures

1. For some models, it requests to send seed code like BFT, to copy these original remote models please follow below procedures.
2. Put the EPIC close to original remote, around 3-5cm, head to head.
3. Keep pressing the button 1 of EPIC, press 3 times button 2 of EPIC. LED emits slow flashing. Release buttons.
4. Keep pressing the button of original you want to copy, LED of EPIC keeps on then emits slow flashing.
5. Press the original remote button to send seed code, LED of EPIC keeps on then emits quick flashing. Procedure finished.

Generating Remote Control

No need original remotes

1. Keep pressing button 1 and button 4 of EPIC, LED emits 3 quick flashing. EPIC enters generating remote mode.
2. Press the button pin code (like 1143) according to “button code” of MODEL LIST in next page, then LED of EPIC emits quick flashing.

P.S: If you don’t finish this process in 5 seconds, generating procedure stops, please start from step 1 again.

3. Press the button of EPIC you want to generate, LED will keep on then turn off. Generating procedure finished.

4. Program EPIC to the receiver by original producers’ procedures.

e.g: In step 3, if you want to generate PUJOL-YELLOW, the button code is 1143. So you press the button 1, button 4, button 3 of EPIC, like pin code.

Compatibilities List (D.T.P with * remarked)