Hospital Use Wound Healing Red Light Therapy Equipment 620 - 640nm Pain Relief

Descriptions:

Red Light Therapy Instrument uses the new light brightness LED light-emitting could light source,which is the same as the new advanced technology of LED red light photodynamic.It emit specific low-energy red light radiation.Red light energy is capable to penetrate body deeply more than 120nm.Our Red-Light Therapy Instrument output power is more than 2w and easy to operation.

Red Light Treatment in clinical cases as follow:

Diminish inflammation, relieve pan

Red Light has good treatment effect on acute, chronic inflammation. Because red light could increased the leukocyte phagocytosis and improve the body’s immune system. Besides, in the early and middle stanges of inflammation PGE will increase in human body. It could relieve pain. After red light irradiation PGE will reduce down, and pain will disappear.

Promote wound and canker healing.

Red light works to stimulate cell growth and has an anti-inflammation effect.fundamentally altering the cell metabolism and circulation, thereby improving the tissues and organs. Red light has good effect on surgery injure.

Characteristics:

Red light is photochemmical not an effect by thermal effects.

Red light absorbed by body mitochondria cell thereby activate enzymes.

Adopt new high brightness LED light-source.

Output wavelength: 620-640mm, narrow, spectrum, chromatographic pure, small wavelength tolerance.

Cold light source, could be used at close quarters, exactly irradiation aera.

Adjust arm support to multi-angle, is apply to different parts.

Red light penetrate the body deeply more than 15mm, body’s moisture can be absorbed at great amount. Widely clinical used, obvious result, reliable security, without side effect.

The output power of red light is high, brightness and energy even. Right diameter dimension (≥90mm).

Main Technique Parameters:

1) Center Wavelength:620nm~640nm;

2) Export power:2-3W

3) Maximum Export:4.8mW

4) Irradiation diameter:100mm from light,diameter >90mm

5) Time setting:1—99min；range :1 min；±10%

6) Rate Power:200W

7) Fuse specifications:2A

Working Conditions:

a)Temperature:5℃～40℃；

b) Relative humidity: 30%～80%;

c) Barometric: 780～1060hPa；

d) Power supply: AC220V,50HZ

Working Principle:

Maintenance:

1. Machine used in dry ventilated place,Not covere it.

2. Can not wipe machine with corrosive or disinfectant liquid.only wet towels.

3. Using the same size to replace damaged parts.

4. Change fuse: There are two pcs fuse underplat, One is in the supply socket,When replacement need take out lug, screwdriver below the socket to outward pry out the insert.The other one is near supply socket unscrew to the sounter-clockwise,In closed state,replace fuse with the same size (2A)

Transportation and Storage:

1. Transportation and storage condition

Temperature:-40℃～55℃

Relative Humidity:≤95%

Atmospheric Pressure:50Kpa～106Kpa

2. Before tranport the machine must be placed accroding to factory package (Suggest that don't shrow Original box and soft materials)

3. Must stored in non corrosive gas,well ventilated condition.Not press.Upward place the box.

4. After installation,only close-move and vertical transport,tilt less than 5 degree.