1:1 Low Speed Dental Handpiece Kit Contra Angle Handpiece/ Straight Handpiece/ Air Motor

Components:

1 pc Straight handpiece
1 pc Contra angle handpiece
1 pc Air motor (2 or 4 holes)

Low Speed Dental Handpiece Features:

1 . Water/air channel isolation. keep perfect performance in instable air pressure and water pressure situation.

2. Contra angle head CA or FG head for your choice

3. 1:1 Directive drive ratio, max 20,000rpm with air motor, 40,000rpm with electric motor

4. Selected materials can withstand high temperature and high pressure at 135 degree

Technical Data

Detailed photos:

After each patient use , maintenance should be done as follows:

1. First remove the diamond burs , and clean up all the teeth on dental handpieces precipitate

2. Use a metal needle to clean the spray holes and fumaroles

Note: The spray holes and diamond burs into 40 -degree angle , fumaroles and diamond burs to a 30 degree angle

3. Place the clean lubricating oil is sprayed into the axial hole 1-2 seconds ( diamond burs is plugged holes )

4. In the bottom of the handpiece were ( with / without quick connector ) two kinds of styling , make the right amount of lubricant is injected into the bottom

5. The handpiece with quick connector combination ( first determine the water switch is turned off )

6. Replace the diamond burs , surrounded by white silk cloth handpiece head ( make sure the needle does not touch the diamond burs and white gauze , so as not to tie )

7. pedal depressed for about 20 seconds , look at whether there is in white gauze on any stain. If there are stains on the white gauze , again, add oil , starting from item 4 continued routine maintenance , know that white gauze until no stain

8. Finally, no more than 135 degrees Celsius temperature and high pressure sterilization