Bw 150 Triplex Mud Water Plunger Pump For Drilling Rig Equipment

Product Description

BW 150 Mud Pump Product Specifications

BW 150 Mud Pump Main Features

1.High quality pump parts, less wearing parts, long service life, low construction cost.

2.Fast suction-discharge speed, high pump efficiency.

3.Less noise and dust, environmental operation

4.Eight gear shift to adjust the flow, large output capacity, simple operation.

BW 150 Mud Pump Applications

BW-150 mud pump is a horizontal three-cylinder reciprocating single-acting piston pump, which can change eight different pressures and flows, and is used to transport flushing fluid (mud, clean water, saponification fluid) to the borehole in geological core drilling engineering It is suitable for supporting small diameter diamond drilling within 1500 meters, and can also be used for medium and low pressure, cement slurry grouting. This pump has multi-speed variable speed, energy saving, compact structure, light weight, high efficiency, durability, safe operation, convenient maintenance and low maintenance costs. This pump is mainly used for geological drilling, geological engineering construction and foundation treatment

BW Mud Pump Working Attentions

(1) Always pay attention to the indication of the pressure gauge. If the indication of the pressure gauge or the safety device does not work after exceeding the pressure, find out the cause, clear the fault and restart.

(2) Pay attention to whether the structure of the mortar pump and motor is normal. In case of any fault, stop immediately, open the discharge valve to reduce the pressure and eliminate the fault.

(3) Pay attention to make the gland press the packing tightly to prevent leakage. If there is still leakage in the compression, replace the packing or piston according to the specific situation.

(4) The consistency of the mixed mortar shall be measured before it enters the pump. During the test, the consistency meter shall be perpendicular to the mortar surface, and it shall be put down easily to sink with its own weight.

(5) After the shutdown at the end of each shift, clean water must be pumped immediately to clean the inside of the pump until it is clean to ensure that the ball valve, slurry discharge port, slurry suction port and slurry discharge valve are clean and smooth.

(6) The upper oil chamber should be filled with oil.