Driver fatigue monitor with signal output 45km/h start-up speed

Description

Driver fatigue monitoring system and method

Method and system for monitoring a driver during movement of the vehicle includes an information obtaining system that obtains information about a driver who traveled the same road at a previous time, and a processor that analyzes the obtained information and vehicle movement to determine whether the driver has lost the ability to continue to control the vehicle. The loss of ability to continue to control the vehicle arises from the driver falling asleep or otherwise being incapable of controlling the vehicle after initially having been awake or otherwise capable of controlling the vehicle. A reactive component is affected by the processor's determination that the driver has lost the ability to continue to control the vehicle, and preferably requires action by the driver to indicate regaining of the ability to operate the vehicle or exerting control over the vehicle to slow the vehicle and bring it to a stop.

I/O and RS232 output optional:

I/O output is only a high/low voltage output, you can get only the alarm signal,the connection is easy. The default setting is high resistance status under normal status, low voltage output when triggered.

RS232 output has alarm signal and picture output, thus you can get the driver's face picture in the center, it need to integrate to the GPS system via protocol.

Power input and output

1. Input: 9-36V, LS803 is suitable for both 12V and 24V vehicle, and have good high voltage protection.
2. very lower power consumption, average current less then 100mA in 12V car, and 60mA in 24V car, similar with leakage from the battery, almost does not consume battery power.
3. I/O output, high resistance status under normal status, low voltage output when triggered.
4. Working Temprature: 0-80℃
5. Working Humility: 10%-90%
6. Weigh:108g
7. Demension: 4.5*10.2cm

Attention:

Non-authorized person, please do not open or repair the device.

Please do not operate the system when driving to avoid dangerous

Please handle carefully, do not drop or impact with hard objectives

Do not use chemicals or cleaning agents to clean the machine, it will damage the machine surfaces or rust the paint.

keep it away from water or moist place, device will be rusted or shortcut in those area.

Do not rip, bend or squeezed the wiring by heavy object, or it will be hot to fire.