Fiber converter of 100Mbps,10M/100M adopt the optical multiplex technology to complete the optical transmission and reception through one fiber ,saving the fiber spending.It is used in the following cases:lacking in fiber resource,hire others fiber or with one failure in function of the bi-cores fiber,and the perfect equipment for removed transmission of bandwidth network.

Product characteristics

1,Adapt wave division multiplex technology and realize the two way transmission on one fiber;

2,Reception with dual wavelength ,and it must be used in pairs in order to improve the system stability.

3,Optional modes of network management and non-network management and non-network management mode;

4,Optional power supply is 5V,1A ; 220V AC/ - 48V DC;

5,Optional (External )outlay power supply and build-in(Inner) power supply;

6,With the function of automatic recovery to prevent system halt;

7,100M,10/100M rates of single fiber receivers avaiable;

8,Maximum transmission distance is 80KM.

Technical specifications

1) Operating standards: IEEE802.3u,IEEE802.3z/ab. 10/100Base-TX,100Base-FX,1000Base-T/SX/LX

2) MAC addresses table : 1k

3) Data buffer: Built-in 128Kb RAM

4) UTP Connector: RJ-45,10/100/1000Mbps, Fiber connector: ST/SC/FC,1000Mbps

5) Cable: UTP: Cat.5 (the max distance up to 100m)

Multimode Fiber: 50/125, 62.5/125um ( 2km or 5km)

Singlemode Fiber: 8/125, 8.7/125, 9/125, 10/125um (20-120km)

6) Flow Control: Full duplex: Supporting standard IEEE802.3x

Half Duplex: back pressure

7) LED: Power, FX SD, FX Link/Act, TX FDX, TX Link/Act

8) Power Requirement: AC 100~240V, 50-60Hz, DC 5V, 1A

9) Ambient temperature: 0~50°C; Storage temperature: -20°C~70°C

10) Relative humidity: 5~90%

11) dimensions: Internal power:30×110×40mm; External power: 26×70×95mm

Wear a grounding device for electrostatic discharge

Install the media cable for network connection

Verify that the voltage of AC power is correct and plug in AC power cord