FLUODE Gas Sampling Bag

FLUODE film has the same characteristics as PVDF (Polyvinylidene fluoride). It is an alternative of PVDF film with low cost.

Features:

*superb strength and low permeability

*excellent chemical inertness and stability

Standard FLUODE Gas Sampling Bag Sizes:0.5L,1L,2L,3L,4L,5L,8L,10L,15L,20L,30L,and 40L or customized size.

Connectors

Side-opening stopcock valve Side-opening PTFE valve plus PTFE fitting

PTFE straight valve plus fitting

It is made of polytetrafluoroethylene (PTFE). The patented design utilizes mouldeling, self-sealing mechanism, no O-ring is inside therefore cross-contamination is eliminated. The PTFE valve can handle gases that there is not corrosive to PTFE. The valve can be used in VOCs analysis.

Product brochures

Operating instructions for FLOUDE bag

1.Avoid filling pressure higher than 6000Pa. Fill gas until the bag is fully expanded, however, it is not so tense when you press it using your finger.

2.Keep away from flame and high temperature when filling and storage. Avoid contacting sharp stuff.

3.Before use, flush sampling bags three times with the gas you want to fill.

4.When using a needle to draw gas from highly elastic septum, squeeze the septum with fingers in order to restore the sealing property after pulling out the needle.

5.Heat-resisitance temperatures should be 150°C to 170°C .

Operating instructions for FLOUDE bag

Detailed introduction

Fluode film has the same same characteristics as PVDF (Polyvinylidene fluoride). It is an alternative of PVDF film with low cost.Our FLUODE gas sampling bags are equipped with renovated, patented valves. Valve materials are polycarbonate . Unlike other popular valves, our valve does not have O-ring inside to prevent leakage so contamination is minimized.