Solution for the bicycle electrophoresis paint
Product Introduction :
HR-4000BLB/HR-6000 the bottom of one black cathode electrophoretic coating, is HLS Paint (Shanghai) Co., Ltd., the eighth generation of independent research and development of electrophoretic coating.
This coating by epoxy acrylate modified, the film also has excellent corrosion resistance and weatherability, smooth appearance and full, suitable as a base topcoat system. In addition, the lead, cadmium, chromium, mercury and other heavy metals, two-component, water dispersible resin, at the same time, previous generations of the product characteristics, have good adaptability to the galvanized steel, almost can be applied to all metal coating,
such as: cold hot rolled steel, galvanized steel, aluminum, zinc Aluminum Alloy plate, stainless steel plate.
This product features shown below:
The appearance of the coating is flat, delicate, smooth. |
Good stability of bath can adaptable for a longer updating cycle. |
Strong anti-corrosion properties, good salt spray resistance workpiece edge. |
The main component :
1, Matrix resin: polyurethane modified epoxy resin
2, Neutralizing agent: organic acid
3, Additives: surface active agent, prevent shrinkage cavity agent, anti-yellowing agent.
Product quality data
Project | Technical data | Test standard | ||
Resin (HR-4000BLB) | Black Paste (HR-6000) | |||
pH | 25℃ | 5.8±0.5 | —— | GB/T 9724 |
Conductivity | 25℃, μs/cm | 1000±300 | —— | HG/T 3334 |
Appearance | —— | Milky white liquid | Black viscous liquid,no agglomeration | Visual |
Storage stability | No stratified state, and there were no obvious difference compared to before storage | In 5-35 ℃ temperature 1 year |
Note: pH, conductivity measurement in the resin/pure water = 1:1 dilution
Storage, packaging and transportation
This product is a water-borne industrial coatings, non-hazardous, non-inflammable and explosive products; transportation to prevent direct sunlight, avoid freezing (>5℃ ); Packaging for 50/60/200L Plastic barrel; in the transport and storage of drums should be maintained clean, avoid charging the dirt brought in on drums during filling tank, again checked and confirmed that the quality of products, including paste resin, emulsions and additives should be indoor storage, good ventilation, dry, protect against freezing and overheating, the storage temperature should be controlled at 5~35℃, products from the date of production, over shelf, experimentation is required to determine whether can continue to use.
Customers in the bicycle industry:
![]() | ![]() |