IEC60335-1 Calibrated Power Cord Tension and Torsion Testing Machine up to 100N Pull Force

1. Introduction of Power Cord Tension and Torsion Testing Machine

The power cord tension and torsion testing machine can be provided with calibration certificate authorized by ISO17025. It is made according to the standards of IEC60335-1 clause 25.15, IEC60598, GB7000, GB2486 and etc., It is applied to test the tension and torque on the terminals of appliances provided with a supply cord and household appliances intended to be permanently connected to fixed wiring with flexible cords, it shall not be possible to push the cord into the appliance to such an extent that the cord or internal parts of the appliacne could be damaged.

The testing method is to draw a mark on the cord at a distance of approximately 20mm from the cord anchorage or other suitable point, and then apply steady pull force to cord for 25 times with a speed of 1 times/s. Then apply a torque as close as possible to the appliance for 1 minute. After the test, the displacement of the cord marking position shall not exceed 2 mm.

2. Parameter of Power Cord Tension and Torsion Testing Machine

Pull force and torque Table

3. Picture of Power Cord Tension and Torsion Testing Machine

FAQ:

1. What is the warranty period of the Power Cord Tension and Torsion Testing Machine?

Answer: It's warranty is 12 months upon you receipt of the equipment

2. Can you provide third-lab calibration certificate?

Answer: Yes, the equipment can send to the third-labs authorized by ISO17025 and get the calibration certificate, but the buyer should undertake the charges.

3. Does this equipment has English operation interface?

Answer: of course, yes, the operation interface has English instruction.

4. Your power plug can not be used in our country, can you change it for us?

Answer: yes, we will change the power plug to fit your demends, please subbmit this issue when you make order.