The ipx34 spray nozzle waterproof tester is designed and manufactured according to IEC60529 clause 14.2.3 and clause 14.2.45 figure 5, IEC60598-1, GB4208, GB7000.1, GB17761 standards. It is suitable for waterproof testing of outdoor electrical and electronic products in terms of rain and water spray, and for waterproof testing of products by certification and testing agencies and manufacturers. The shower is mainly composed of a brass nozzle, a movable water baffle, a counterweight, a pressure gauge and a stainless steel valve. The equipment is consisted by spray nozzle, water tank and control box.
IEC60529 Degrees of protection provided by enclosures (IP Code) Figure 5
IEC60598-1 Luminaires - Part 1: General requirements and tests
ISO20653 Road Vehicles - Degrees of protection (IP-Code) - Protection of electrical equipment against foreign objects, water and access
Model | IPX34AS |
Outer size (L*W*H) | 870mm*600mm*950mm (control box) 370mm*115mm*165mm (spray nozzle) |
Spray nozzle diameter | 102mm |
Number of holes | 121 |
Hole diameter | Φ0.5mm |
Holes position | 1 hole at center 2 inner circles of 12 holes at 300 pitch 4 outer circles of 24 holes at 150pitch |
Outer diameter of water inlet | Φ16mm |
Outer diameter of water pipe | Φ28mm |
Flow rate | 10L/min±5% |
Flowmeter adjustment method | Manual adjustment |
Water pressure range | 50-150Kpa |
Flowmeter display | Glass flow meter |
Capacity of water tank | 150L |
Working power | 220V/50Hz |
Water source | 1. The user is required to configure a water source for the equipment at the installation site, with a water pressure not less than 0.2Mpa, and install a 4/8 inch faucet. 2. The faucet is not more than 2 meters away from the equipment |
Requirement for the site | The ground is level, the drainage is unobstructed, the ground and walls are waterproofed, and the floor drain or drainage ditch is set |
4. Figure: