Details for Elevator Lift Photoelectric Beam Sensor Auto-Door Control System M-218D

Pictures for Elevator Lift Photoelectric Beam Sensor Auto-Door Control System M-218D

Single beam of safety light contains: 1 control box, 1 pair of electric eyes, 1 set of wiring

Double beam safety light contains: 1 control box, 2 pairs of electric eyes, 2 sets of wiring

The single beam must be connected to the A group (choose to connect to the white socket), and the double beam must be connected to the AB group (select the white and black sockets). When the electric eye head is installed, the hole diameter of the drill hole is 13mm. When using a single beam, it is recommended to install it at a height of 60cm from the ground.
In the case of double beams, one set is installed at a height of 30cm from the ground, and the other set is installed at a height of 90cm from the ground.

There is a certain range of automatic chasing and chasing of the electric eye head that transmits and receives the opposite beam, but please be sure to align it when installing to ensure the consistency of the horizontal and vertical directions. Between the transmitters and receivers, one should pay attention not to place bonsai or other stacked objects in order to avoid blocking malfunctions.
The system has excellent anti-interference ability of natural light, but when installing, it should try to avoid the direct frontal electric eye of strong sunlight. Make sure that the height of the safety light from the ground is not less than 20cm.

The main technical parameters

Power supply AC/DC12~30V Receiver cable (black) 5.5m
Static power supply 18mA Number of beams Single beam or double beam optional
Operating current 58mA Working temperature -42℃~+45℃
Maximum sending and receiving distance 10 meters Working moderation 10~90%RH
Output contact normally open and normally closed Jump dial selection Dimensions (main controller) 105.5(L)x53.4(W)x28.5(H)mm
External wiring launch line (blue) 5.5 meters Appearance size (electric eye head) 19(L)x13(D)mm