o-ring box, o ring kit for Hitachi Komatsu CAT Volvo Doosan Hyundai Kobelco Kato Sumitomo

Specification:

When installing, you should strictly clean all parts of the opened hydraulic system. It is best to use special tools to prevent fingers from being scratched by sharp metal edges.

When replacing the sealing ring, check the groove of the sealing ring strictly, remove the dirt, and polish the bottom of the groove.

In order to prevent damage and cause oil leakage, it must be operated in accordance with the regulations. At the same time, the machine cannot be overloaded for a long time or run in a relatively harsh environment.

Product you might interest in:

1. Do not open the seal package if unnecessary, otherwise the dust will stick to the seal or scratch it.

2. Store in cool place, not on sunlight place. UV and moisture will accelerate the deterioration of rubber and plastics and dimensional changes

3. Carefully pack, store unpackaged product, do not glue or put into impurities, keep the original state. Keep the Nylon seal package close to prevent moisture cause dimensional changes

4. Do not put seals near heat sources, such as boilers, stoves. Otherwise heat will accelerate the aging of seals

5. Do not put seals near the motor and other place where produces ozone

6. Do not use a needle, wire, rope hang seals, otherwise, would cause the seal deformation, damage the lip

7. Sometimes, there are color change or white powder on the seal surface (frost phenomenon), this will not affect the performance of the seal

Our main products:

With bulk package:

• SPGW, SPGO, OK SEAL, SPG, OUY

• IDI, HBY, HBTS, SPN

• GRS, ROI

• DKB, DKBI

• WR, RYT, KZT, DU

• BRT, N4W, TFG, TFP, O rings

• Connector, Pilot control seal, Gas seal

With retail package:

• O ring box

• Excavator seals kit: of Boom, Arm, Bucket, Center joint, Track adjuster, Travel motor, Swing motor, Control valve, Hydraulic pump, etc.

• Rock breaker seals kit