paper coffee cup making machine paper cup cutting and printing machine machine paper cup
Machine model: high-speed simple paper cup machine
Backside Soldering : Copper Heater Ultrasonic Heater
Raw material : single side PE coated paper (popular hot drink cup) single/double PE coated paper (popular hot drink cup and cold drink cup)
Total weight : Gw /NW:1750 kgs/1650 KgS.
Working air source (ultrasonic): Air pressure 0.4MPa a. machine.
Cup bottom heating: heater knurling (single-sided PE paper is heated and knurled; double-sided PE paper is knurled with cooling device circular water.)
Bottom knurling: heat knurling (if using single layer PE coated paper)
Electric System:
High-quality brand electrical systems, such as Delta, Schneider.
The PLC control system adopts the Delta brand, which is made in Taiwan and is reliable.
quality.
Servo Motor:
The bttom paper feeding is controlled by servo motor and stepping motor,which greatly improve paper feeding in high precision and
high efiency way.(more stable ,less troubles and save bottom paper)
Paper size : | 2~16 oz (replaceable die, max cup height 136mm, max bottom width 76mm.) |
Rated speed: | 70-80 per minute (the speed is affected by the size of the paper cup, paper quality and thickness), the running speed is stable, 75 per minute |
Paper material: | 140-250 GSM.140~350gsm. |
Power requirements: | 50/60 Hz.380V/220V (preferably use 380V, 3Phase) or special power requirements |
Total power : | 6.5 kw, 7.5 kw. |
Total weight : | Gw /NW:1750 kgs/1650 Kgs. |
Excerpted from the Internet, for reference only
Push the nose bridge line structure:
The structure of the servo motor and the crank slider is used to push the nose bridge, and the nose bridge is also controlled by a single servo, which is different from other mechanical structures.
Embossed structure:
The power of the embossing mechanism also comes from the power shaft, and this power shaft is the same as the power shaft of the previous nose bridge wire feeding & loading mechanism.
The drum has a protruding circle, which is used to cut out the hole where the breathing valve is installed, and the cut waste is discharged through the hopper.