Cattle Feed Manufacturing Plant Animal Cow Feed Production Line

Outstanding advantages:

1. The pelletizer system was comprehensively upgraded, and the production efficiency was again increased by 10-15%;

2, the improvement of pelleting chamber and transmission system, so that D type pelleting machine capacity increase 10-15% capacity, such as according to two 508 lines annual output of 180,000 tons of feed, a year in the same power consumption, can produce about 18,000 tons of feed, such as according to the production of a ton of feed 20 degrees meter, It can save 18,000 tons *20 degrees *0.5 yuan/degree ≈ 180,000 yuan;

3, the conditioning time can be increased to 35 seconds, greatly improving the degree of maturation of feed;

4, now pelletizer box is made of diesel engine cylinder block material, the service life is increased more than twice;

5, the surface paint spraying process, the stain resistance is greatly improved, really durable.

2. The transmission part of the whole machine (including the motor) is made of Swiss and Japanese high-quality bearings to ensure efficient, stable and low noise transmission
1. The main drive adopts high-precision gear drive, and the ring mold adopts quick-discharge hoop type. The output is about 20% higher than that of belt drive type.

2. All stainless steel and large reinforcement feeder, adopt frequency conversion speed regulation control, to ensure the high quality of pellet feed.

4. Alloy steel ring die is made by international advanced German gun drill and American vacuum furnace heat treatment manufacturing process, with long service life, smooth grain and high quality.

5. The international advanced level of compensation snake snake spring coupling, with novel structure, compact, safe, low noise, low fault performance.

1. The output of the feed pellet machine is too low or even granules or a lot of powder. Although this problem does not occur often, if it appears, it means that you have not grinded the pressure roller and the grinding disc during the grinding process of the pellet machine. The reason for the similar problem may be the poor finish of the grinding disc for the first time. After grinding the disc with the abrasive or after using for a period of time, the output of the pellet machine will reach the normal output.
2. If the moisture content of the feed is not well mastered, it will affect the discharge of the pellet machine. The moisture in the raw material should be controlled at 13%-20%, because the pellet machine has the function of drying and curing, and the moisture in the raw material is in the pellet machine pressing process. The pellets that are dried in the pellet machine can be bagged after being dried for 5-10 minutes under normal temperature conditions.
3. The gap between the pressure roller and the grinding disc of the pellet machine is too large, which may be one of the reasons that the pellet machine does not discharge. Adjust the gap between the pressure roller and the grinding disc, screw the pressure roller with one hand, adjust the corresponding bolt, adjust When the pressure rollers on both sides are swaying, slightly tight, it means that the pressure roller and the grinding disc have been adjusted.