ADM2587EBRWZ IC Circuit Board Chips Electronics Components Chip IC Electronics

Signal and Power Isolated RS-485 Transceiver with ±15 kV ESD Protection

FEATURES

Isolated RS-485/RS-422 transceiver, configurable as half or full duplex isoPower® integrated isolated dc-to-dc converter ±15 kV ESD protection on RS-485 input/output pins

Complies with ANSI/TIA/EIA-485-A-98 and ISO 8482:1987(E)

ADM2582E data rate: 16 Mbps ADM2587E data rate: 500 kbps 5 V or 3.3 V operation

Connect up to 256 nodes on one bus Open- and short-circuit, fail-safe receiver inputs

High common-mode transient immunity: >25 kV/μs

Thermal shutdown protection Safety and regulatory approvals (pending)

UL recognition: 2500 V rms for 1 minute per UL 1577 VDE

Certificates of Conformity DIN V VDE V 0884-10

(VDE V 0884-10):2006-12 VIORM = 560 V peak

Operating temperature range: −40°C to +85°C

Highly integrated, 20-lead, wide-body SOIC package

APPLICATIONS

Isolated RS-485/RS-422 interfaces Industrial field networks Multipoint data transmission systems

VCC −0.5 V to +7 V Digital Input Voltage (DE, RE, TxD) −0.5 V to VDD + 0.5 V

Digital Output Voltage (RxD) −0.5 V to VDD + 0.5 V

Driver Output/Receiver Input Voltage −9 V to +14 V

Operating Temperature Range −40°C to +85°C

Storage Temperature Range −55°C to +150°C

ESD (Human Body Model) on A, B, Y, and Z pins ±15 kV

ESD (Human Body Model) on Other Pins ±2 kV

Lead Temperature Soldering (10 sec) 260°C

Vapor Phase (60 sec) 215°C Infrared (15 sec) 220°C

GENERAL DESCRIPTION

The ADM2582E/ADM2587E are fully integrated signal and power isolated data transceivers with ±15 kV ESD protection and are suitable for high speed communication on multipoint transmission lines.

The ADM2582E/ADM2587E include an integrated isolated dc-to-dc power supply, which eliminates the need for an external dc-to-dc isolation block.

They are designed for balanced transmission lines and comply with ANSI/TIA/EIA-485-A-98 and ISO 8482:1987(E). The devices integrate Analog Devices, Inc., iCoupler® technology to combine a 3-channel isolator, a three-state differential line driver, a differential input receiver, and Analog Devices isoPower dc-todc converter into a single package.

The devices are powered by a single 5 V or 3.3 V supply, realizing a fully integrated signal and power isolated RS-485 solution. The ADM2582E/ADM2587E driver has an active high enable. An active low receiver enable is also provided that causes the receiver output to enter a high impedance state when disabled.

The devices have current limiting and thermal shutdown features to protect against output short circuits and situations where bus contention may cause excessive power dissipation.

The parts are fully specified over the industrial temperature range and are available in a highly integrated, 20-lead, widebody SOIC package.

The ADM2582E/ADM2587E contain isoPower technology that uses high frequency switching elements to transfer power through the transformer. Special care must be taken during printed circuit board (PCB) layout to meet emissions standards.

Refer to Application Note AN-0971, Control of Radiated Emissions with isoPower Devices, for details on board layout considerations.