OPT8320NBP HVAC Temperature Sensors Image Sensors 3D time-of-flight (ToF) sensor and controller 56-COG 0 to 70

1 Features

• Imaging Array:

• – 80 × 60 Array

• – 1/6” Sensor Format

• – Pixel Pitch: 30 μm

• – Frame Rate: Scalable Up to 1000-FPS Depth Output Rate with an Internal Raw Rate of 4000 FPS

• Optical Properties:

  • – Responsivity: 0.35 A/W at 850 nm

  • – Demodulation Contrast: 70% at 50 MHz

  • – Demodulation Frequency: 10 MHz to 100 MHz

• Output Interface:

  • – Digital Video Port (DVP): 8 Data Lanes, HD and VD Pins, and Clock

  • – Synchronous Serial Interface (SSI): 1 Data Lane, Clock, and Chip Select

• Timing Generator:

  • – Sensor Addressing Engine

  • – Modulation Control

  • – De-Aliasing

  • – Master, Slave Sync Operation

  • – High Dynamic Range Operation

• Depth Engine:

  • – Pixel Binning

  • – De-Aliasing

  • – Histogram

  • – Calibration

• Power Supply:

  • – 3.3-V I/O, Analog

  • – 1.8-V Analog, Digital, I/O

  • – 1.8-V Demodulation (Typical)

• Optimized Optical Package (COG-56):

  • – 8.03mm×5.32mm×0.745mm

  • – Integrated Optical Band-Pass Filter (830 nm to 867 nm)

  • – Optical Fiducials for Easy Alignment

• Built-In Illumination Driver for Low-Power Applications

• Operating Temperature: 0°C to 70°C

2 Applications

• Depth Sensing:

• – Location and Proximity Sensing

• – 3D Scanning

• – 3D Machine Vision

• – Security and Surveillance

• – Gesture Controls

• – Augmented and Virtual Reality

3 Description

The OPT8320 time-of-flight (ToF) sensor is part of the TI 3D ToF image sensor family. The device is a high-performance, highly-integrated, complete system-on-chip (SoC) for array depth sensing, consisting of a versatile timing generator (TG), an optimally designed analog-to-digital converter (ADC), a depth engine, and an illumination driver.

The programmability of the built-in TG offers the flexibility to optimize for various depth-sensing performance metrics [such as power, motion robustness, signal-to-noise ratio (SNR), and ambient cancellation]. The built-in depth engine computes the depth data from the digitized sensor data. In addition to the phase data, the depth engine provides auxiliary information consisting of amplitude, ambient, and flags for each pixel and the full-array statistical information in the form of a histogram.

Device Information