High speed corrugated paper board production line Corrugated board production line for double wall cardboard Production line for 5 ply corrugated paper sheet

Products Description

Nowadays, the manufacture of corrugated cardboards is becoming increasingly mature. All kinds of corrugated machines emerge as times require. We devoted itself to development of the most advanced and highest quality corrugated board making machine for about 20 years. Today, our corrugated cardboard production line is our great contribution to this packaging industry.

A Complete Corrugating Board Production Line Includes The Following Machines:Mill Roll Stand, Pre-Heater, Splicer, Single Facer, Over Bridge, Multi-Pre-Heater, Glue Machine, Double Baker, Slitter Scorer, Cutoff, Stacker, And Ect.

Raw Paper Roll Feeded to The Roll Stand, After Heated And Moisture Adjusted By The Per-Heater, Raw Paper Will Go To The Single Facer, Corrugated By It, And Gluing Together With Another Raw Paper To Become Single Faced Corrugating Paper, Then Conveyed Through The Over Bridge, Re-Heated By Multi-Pre-Heater, After Glued By Glue Machine, Jointed By The Double Backer, Continuous Corrugating Board Comes Out.

After Slitting And Scorring By Slitter Scorer And Transverse Cutting By Cutoff, Corrugating Board With Different Sizes Are Produced. At Last, These Different Sizes Corrugating Board Will Be Stacked, Calculated.

Heating Way:Steam Heating.

The Photo of Machine

Features

1. Layered independent motor drive, adopts scattered-tooth gear box, save more than 20% electricity compared with the traditional gear box

2. To avoid the inconsistent resistance between the upper and lower belts, to avoid skid on rubber roller of drive wheel, to avoid top and bottom belt out-of-sync caused by aging canvas belt.

3. Canvas belt guiding roll, our unique design, when the canvas wear and cause slippery, problem can be solved by adjusting the guiding roll, to increase the friction between canvas belt and rubber roll’s wrap angel, take full advantage of the canvas belt’s service life.

4. Fasting braking, only takes 2 seconds to directly stop when hot plates speed at 120m/min. This not only reduce the waste rate, but also saves electricity, production line 150m/min – 300m/min can be used